Design of a Radial Mode Piezoelectric Transformer for a Charge Pump Electronic Ballast with High Power Factor and Zero Voltage Switching

Electrical Engineering (ABSTRACT) In a conventional electronic ballast for a fluorescent lamp, inductor-capacitor-transformer tank circuit is used. A Piezoelectric Transformer (PT) can potentially be used to replace such a tank circuit to save space and cost. In the past, ballast design using a PT requires selecting a PT from available samples which are normally not matched to specific application and therefore resulting in poor performance. In this thesis, a design procedure was proposed for designing a PT tailored for a 120-V 32-W electronic ballast with high power factor, high efficiency and Zero-Voltage-Switching (ZVS) of the inverter transistors that drive the lamp. This involves selection of PT materials, determination of geometries and the number of physical layers of the PT. A radial mode piezoelectric transformer prototype based on this design process was fabricated by Face Electronics Inc. and was tested experimentally, the results showed that the ballast using this custom-made PT achieved high power factor, Zero-Voltage-Switching and a 83% overall efficiency. iii Acknowledgments