Extension of Flutter Boundaries Using In-Flight Receptance Data

Public reporting burden for this collection of information is estimated to average 1 hour per response, including the time for reviewing instructions, searching existing data sources, gathering and maintaining the data needed, and completing and reviewing the collection of information. Send comments regarding this burden estimate or any other aspect of this collection of information, including suggestions for reducing the burden, Respondents should be aware that notwithstanding any other provision of law, no person shall be subject to any penalty for failing to comply with a collection of information if it does not display a currently valid OMB control number. This report describes an experimental study involving the implementation of the method of receptances to control binary flutter in a wind-tunnel aerofoil rig. The aerofoil and its suspension were designed as part of the project. The advantage of the receptance method over conventional state-space approaches is that it is based entirely on frequency response function measurements, so that there is no need to know or to evaluate the system matrices describing structural mass, aeroelastic and structural damping and aeroelastic and structural stiffness. There is no need for model reduction or the estimation of unmeasured states, for example by the use of an observer. It is demonstrated experimentally that a significant increase in the flutter margin can be achieved by separating the frequencies of the heave and pitch modes. In the test carried out so far it has been found that simply increasing the damping, principally of the heave mode, is less effective in increasing the flutter margin than separating the heave and pitch frequencies.