TURN-BY-TURN BPM ELECTRONICS BASED ON 500 MHz LOG-RATIO AMPLIFIER
نویسندگان
چکیده
Log-ratio processor working at 500MHz applied to turn-by-turn beam position measurement was implemented. The processor circuit consists of two logarithmic amplifiers and a subtraction circuit. The output value is proportional to beam position. Before, the upper usable frequency of logarithmic amplify is lower than 500MHz. At present, several manufacturers support higher upper usable frequency of logarithmic amplifiers. In this paper, we will present the performance test result of the 500MHz log-ratio processor applied to turn-by-turn BPM electronics.
منابع مشابه
Analog Front-end Electronics for Beam Position Measurement on the Beam Halo Measurement
Enhancements have been made to the log-ratio analog front-end electronics based on the Analog Devices 8307 logarithmic amplifier as used on the LEDA accelerator. The dynamic range of greater than 85 dB, has been extended to nearly the full capability of the AD8307 from the previous design of approximately 65 dB through the addition of a 350 MHz band-pass filter, careful use of ground and power ...
متن کاملImproving Linearity of CMOS Variable-gain Amplifier Using Third-order Intermodulation Cancellation Mechanism and Intermodulation Distortion Sinking Techniques
This paper presents an improved linearity variable-gain amplifier (VGA) in 0.18-µm CMOS technology. The linearity improvement is resulted from employing a new combinational technique, which utilizes third-order-intermodulation (IM3) cancellation mechanism using second-order-intermodulation (IM2) injection, and intermodulation distortion (IMD) sinking techniques. The proposed VGA gain cell co...
متن کاملPerformance of the Beam Position Monitor System for the SLAC PEP-II B Factory
the beam position monitor (BPM) system for the SLAC PEP-II B Factory was designed to measure the positions of single-bunch single-turn to multibunch multi-turn beams in both rings of the facility. Each BPM is based on four button-style pickups. At most locations the buttons are connected to provide single-axis information (x only or y only). Operating at a harmonic (952 MHz) of the bunch spacin...
متن کاملNew Beam Position Monitor System Design for the APS Injector*
Demands on the APS injector have evolved over the last few years to the point that an upgrade to the existing beam position monitor (BPM) electronics is required. The injector is presently being used as a source for both the low-energy undulator test line (LEUTL) project and the top-up mode of operation. These new requirements and the fact that many new rf receiver components are available at r...
متن کاملUpgrade to Initial Bpm Electronics Module and Beamline Components for Calibration of the Leda Beam Position Measurements*
The Low-Energy Demonstration Accelerator (LEDA), designed and built at the Los Alamos National Laboratory, is part of the Accelerator Production of Tritium (APT) program and provides a platform for measuring high-power proton beam-halo formation. Beam Position Monitors (BPMs) are placed along the FODO lattice and the HEBT. The BPM systems employing logratio processor electronics have recently b...
متن کامل