Microstructural characterizations of 14Cr ODS ferritic steels subjected to hot torsion
نویسنده
چکیده
CEA, DEN, Service de Recherches Métallurgiques Appliquées, 91191 Gif-sur-Yvette, France Centre de mise en forme des matériaux (CEMEF), Mines Paris-tech, CNRS UMR 7635, BP 207, 1 rue Claude Daunesse, 06904 Sophia Antipolis Cedex, France c Laboratory of Thermomechanical Metallurgy – PX Group Chair, Ecole Polytechnique Fédérale de Lausanne (EPFL), Rue de la Maladière 71b – CP 526, CH-2002 Neuchâtel, Switzerland
منابع مشابه
High heat flux testing of 12–14Cr ODS ferritic steels
0022-3115/$ see front matter 2009 Published by doi:10.1016/j.jnucmat.2009.09.022 * Corresponding author. E-mail address: [email protected] (Z. Oksiut The thermal performance of Fe–(12–14)Cr–2W–0.3Ti–0.3Y2O3 ODS reduced activation ferritic steels, which are considered as candidate first wall materials for the future fusion power reactors and were manufactured by mechanical alloying in hydr...
متن کاملCurrent Status of Reduced-Activation Ferritic/Martensitic Steels R&D for Fusion Energy
Reduced-activation ferritic/martensitic (RAF/M) steels have been considered to be the prime candidate for the fusion blanket structural material. The irradiation data obtained up to now indicates rather high feasibility of the steels for application to fusion reactors because of their high resistance to degradation of material performance caused by both the irradiation-induced displacement dama...
متن کاملDetermining the Hot Deformation Temperature Range of Medium Carbon Ni-Cr-Mo Low Alloy Steels using Hot Tensile and Hot Torsion Tests
The aim of this study was to investigate the suitable temperature range for hot deformation of three medium carbon Ni-Cr-Mo low alloy steels by hot tensile and hot torsion tests. Hot tensile tests were carried out in the te,prature range of 850-1150°C at a constant strain rate of 0.1 s-1 until fracture. Then, the tensile flow behavior, hot ductility and microstructural evolution of the steels w...
متن کاملOptimisation of the Chemical Composition and Manufacturing Route for ODS RAF Steels for Fusion Reactor Application
As the upper temperature for use of reduced activation ferritic/martensitic (RAFM) steels is presently limited by a drop in mechanical strength at about 550°C, Europe, Japan and the US are actively researching steels with high strength at higher operating temperatures, mainly using stable oxide dispersion. In addition, the numerous interfaces between matrix and oxide particles are expected to a...
متن کاملEffect of Composition on the Recrystallization Behavior of if Steels During Simulated Hot Strip Rolling
Flow curves are generated in muti-pass torsion tests for a titanium stabilized and a niobium stabilized IF steel. Two types of test schedule are used, one based on plate rolling and the other approximating strip rolling. The purpose of the former is to define the three critical temperatures of steel rolling. The strip schedules are varied in order to investigate the influence of increasing the ...
متن کامل