Fabrication and Characterization of SPR Based Fiber Optic Probe Using e beam Deposition
نویسنده
چکیده
A surface plasmon resonance based fiber optic probe has been fabricated using electron beam deposition. The fabricated probe has been characterized using sucrose solution. It has been observed that the resonance wavelength i.e. SPR wavelength increases with increasing concentration of sucrose solution. The experimental results so obtained have been compared with theoretically simulated model results and are found to be in good agreement qualitatively. This study will found applications in fabrication of biochemical sensors. Copyright © 2014 IFSA Publishing, S. L.
منابع مشابه
Fabrication and Characterization of the Fiber Optical Taper for a Surface Plasmon Resonance Sensor
For a fiber optical surface plasmon resonance (SPR) sensor a short part of its cladding should be removed to coat a thin layer of a metal. Usually this is problematic when an optical fiber with small core diameter is used. In this paper, a new method using µliter droplet of the HF acid for short fiber optical taper fabrication is reported. Using this method in a multi-mode optical fiber w...
متن کاملFabrication and Characterization of a SPR Based Fiber Optic Sensor for the Detection of Chlorine Gas Using Silver and Zinc Oxide
A fiber optic chlorine gas sensor working on surface plasmon resonance (SPR) technique fabricated using coatings of silver and zinc oxide films over unclad core of the optical fiber is reported. The sensor probe is characterized using wavelength interrogation and recording SPR spectra for different concentrations of chlorine gas around the probe. A red shift is observed in the resonance wavelen...
متن کاملAn In-situ Real-Time Optical Fiber Sensor Based on Surface Plasmon Resonance for Monitoring the Growth of TiO2 Thin Films
An optical fiber sensor based on surface plasmon resonance (SPR) is proposed for monitoring the thickness of deposited nano-thin films. A side-polished multimode SPR optical fiber sensor with an 850 nm-LD is used as the transducing element for real-time monitoring of the deposited TiO2 thin films. The SPR optical fiber sensor was installed in the TiO2 sputtering system in order to measure the t...
متن کاملA reflection-based localized surface plasmon resonance fiber-optic probe for biochemical sensing
We report the fabrication and characterization of an optical fiber biochemical sensing probe based on localized surface plasmon resonance (LSPR) and spectra reflection. Ordered array of gold nanodots was fabricated on the optical fiber end facet using electron-beam lithography (EBL). We experimentally demonstrated for the first time the blue shift of the LSPR scattering spectrum with respected ...
متن کاملFabrication of optical fiber probes for scanning near - field optical microscopy
MSURJ • Volume 3, Issue 1 Abstract Many areas of cell biology have remained unexplored due to the limitations of conventional optical microscopy for image structures smaller than the diffraction limit of light. Scanning near-field optical microscopy (SNOM) is an emerging technique which allows sub-diffraction limit optical resolution and hence access to nanoscale structures such as those in bio...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره شماره
صفحات -
تاریخ انتشار 2014