Local Dynamics of Bulk Polybutadienes of Various Microstructures: Comparison of Theory with NMR Measurements

نویسندگان

  • C. Baysal
  • B. Erman
  • L. Monnerie
چکیده

Theoretical and experimental results are presented for the local dynamics of bulk polybutadienes (PB) of various microstructures, i.e., various fractions of cis and trans units. The cooperative kinematics (CK) method is used to analyze the specific mechanism of motion involved in the rotational isomerization of the bonds belonging to the cis and trans units. Correlation times measured by NMR experiments at room temperature are reported for various microstructures and interpreted using the CK model. The effective monomeric friction coefficient and its dependence on the microstructure of PB are seen to dominate the rate of local motions. On the other hand, the specific mechanism of relaxation shows little dependence on the frictional resistance or on the composition of the polymer, but is uniquely defined depending on the given conformational state, cis or trans, of the double bond of the repeat unit. The amplitude of the spatial reorientations of the methylene C-H bond vectors and the frequencies of isomeric jumps are the two contributions affecting the observed correlation times in NMR experiments. The frequencies of isomeric jumps are comparable in cis and trans units, in general. On the other hand, the C-H bonds belonging to cis units are shown to undergo significantly larger amplitude reorientations during the cooperative motions accompanying bond isomerization, compared to C-H bonds in trans units. This latter effect explains the differences in the NMR correlation times of cis and trans units in the chains of various microstructures.

برای دانلود رایگان متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Comparison of Hartree Factor and Density Function Theory in Calculating Coating Constants and NMR Parameters of Chromate and Molecular Complexes with Alanine and Glycine

Chromium and molybdenum are intermediate elements of a periodic table group, both of which are both low but essential in nutrition because they play a key role in the metabolism of the chemical activity of the body. Anion analysis of these compounds in order to compare the properties of the elements of the periodic table in one The group is from the periodic table. In this paper, the quantum ch...

متن کامل

Diffusive Dynamicsof Binary Lennard-Jones Liquid in the Presence of Gold Nanoparticle: A Mode Coupling Theory Analysis

Molecular dynamics simulation has been performed to analyze the effect of the presence of gold nanoparticle on dynamics of Kob-Anderson binary Lennard-Jones (BLJ) mixture upon supercooling within the framework of the mode coupling theory of the dynamic glass transition. The presence of gold nanoparticle has a direct effect on the liquid structure and causes the peaks of the radial distribution ...

متن کامل

Analyzing Iran’s Local and Regional Droughts Using the Theory of Runs and Standardized Precipitation Index (SPI)

The primary objective of the present study is the investigation of the various properties of Iran’s local and regional droughts based on the theory of runs and standardized precipitation index (SPI). Thus, in order to accomplish this goal, the annual precipitation data of 63 synoptic stations were procured from Iran’s meteorological organization for a 30-year period (1986-2015).. First, based o...

متن کامل

Exploration of the Significance of Autocatalytic Chemical Reaction and Cattaneo-Christov Heat Flux on the Dynamics of a Micropolar Fluid

During the homogeneous-heterogeneous autocatalytic chemical reaction in the dynamics of micropolar fluid, relaxation of heat transfer is inevitable; hence Cattaneo-Christov heat flux model is investigated in this report. In this study, radiative heat flux through an optically thick medium is treated as nonlinear due to the fact that thermal radiation at low heat energy is distinctly different f...

متن کامل

The Comparison of MgO and TiO2 Additives Role on Sintering Behavior and Microstructures of Reaction-Sintered Alumina-Zirconia-Mullite Composite

Alumina-Mullite-Zirconia ceramic composites were prepared by reaction sintering of alumina, zircon mixture and the sintering aids of magnesia and titania at temperatures of 1400 and 1600 C for 2 hours. The development of different phases and microstructures of the composites were analysed to assess the relative influence of the additives on the formation of alumina-zirconia-mullite compos...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 1997