Boiler-Turbine Control System Design Using a Genetic Algorithm - Energy Conversion, IEEE Transactions on
نویسنده
چکیده
Abstrac t This paper discusses the application of a genetic algorithm to control system design for a boiler-turbine plant. In particular we study the ability of the genetic algorithm to develop a proportional-integral (PI) controller and a state feedback controller for a non-linear multiinput/multi-output (MIMO) plant model. The plant model is presented along with a discussion of the inherent d i f f i c u l t i e s in such contro l l er development. A sketch of the genetic algorithm (GA) is presented and its strategy as a method of control system design is discussed. Results are presented for two different control systems that have been designed with the genetic algorithm.
منابع مشابه
Modeling, Optimization and exergoeconomic analysis a multiple energy production system based on solar Energy, Wind Energy and Ocean Thermal Energy Conversion (OTEC) in the onshore region
In the present study, investigated an energy production system using three types of renewable energy: solar, wind and ocean thermal energy with climatic conditions and close to areas with high potential for the OTEC system, Has a good position in terms of wind speed and solar radiation, used them as energy sources. The proposed system is designed and evaluated based on the total daily electrici...
متن کاملDesign and optimization of an energy hub based on combined cycle power plant to improve economic and exergy objectives
This paper uses the energy hub concept to meet the water, heat and electricity demand of a power plant in the Qeshm island in south of Iran. Given the power plant’s high potential for waste heat recovery and some scenarios were considered using the hub energy concept based on energy, exergy, environmental and economic analyzes in terms of meeting the demands of the hub and purchasing/selling en...
متن کاملA coordinated MIMO control design for a power plant using improved sliding mode controller.
For the participation of the steam power plants in regulating the network frequency, boilers and turbines should be co-ordinately controlled in addition to the base load productions. Lack of coordinated control over boiler-turbine may lead to instability; oscillation in producing power and boiler parameters; reduction in the reliability of the unit; and inflicting thermodynamic tension on devic...
متن کاملطراحی کنترل کننده پیش بین سیستم بویلر- توربین
A nonlinear model predictive control (NMPC) algorithm based on neural network is designed for boiler- turbine system. The boiler–turbine system presents a challenging control problem owing to its severe nonlinearity over a wide operation range, tight operating constraints on control move and strong coupling among variables. The nonlinear system is identified by MLP neural network and neur...
متن کاملWind Turbine Transformer Optimum Design Assuming a 3D Wound Core
A wind turbine transformer (WTT) is designed using a 3D wound core while the transformer’s total owning cost (TOC) and its inrush current performance realized as the two objective functions in a multi-objective optimization process. Multi-objective genetic algorithm is utilized to derive Pareto optimal solutions. The effects of inrush current improvement on other operating and design parameters...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره شماره
صفحات -
تاریخ انتشار 2004