Centrifuge modeling of one-step tests
نویسندگان
چکیده
Centrifuge modeling of one-step outflow tests for unsaturated parameter estimations H. Nakajima ∗ and A. T. Stadler ∗∗ Geoscience Research, Idaho National Laboratory, Idaho Falls, Idaho, USA ∗ now at: Center for Deep Geological Environments, National Institute of Advanced Industrial Science and Technology (AIST), Tsukuba, Ibaraki, Japan ∗∗ now at: URS Corporation, Cleveland, Ohio, USA Received: 9 March 2006 – Accepted: 17 March 2006 – Published: 16 May 2006 Correspondence to: H. Nakajima ([email protected])
منابع مشابه
Centrifuge modeling of one-step outflow tests for unsaturated parameter estimations
Centrifuge modeling of one-step outflow tests were carried out using a 2-m radius geotechnical centrifuge, and the cumulative outflow and transient pore water pressure were measured during the tests at multiple gravity levels. Based on the scaling laws of centrifuge modeling, the measurements generally showed reasonable agreement with prototype data calculated from forward simulations with inpu...
متن کاملThe Effect of Lateral Loading Parameters on Monopile Behavior Based on Physical Modeling
Monopiles are the most common type of foundation for offshore wind turbines (OWT). Monopiles have been used in more than 80% of the offshore wind turbines. A monopile will be affected by millions of lateral load cycles during the operating period, which will cause its rotation and lateral deformation. The rotation and the deformation are dependent on the soil properties, monopile specification,...
متن کاملInfluence of modeling material on undercut slope failure mechanism
A series of physical modeling tests were conducted by means of a beam type geotechnical centrifuge machine in order to investigate the drainage impact on the slope failure mechanism under centrifugal acceleration. Meanwhile, the phenomenon of stress redistribution in undercut slopes and the formation of arching effect were studied. For this purpose, a poorly graded sandy soil (Silica sand No. 6...
متن کاملFinite Difference Numerical Evaluation of Liquefaction with Effective Stress Method and Numerical Estimation of Liquefaction in Bandar Abbas’s Mosque Project (Case Study)
Introduction Estimation of Liquefaction is one of the main objectives in geotechnical engineering. For this purpose, several numerical and experimental methods have been proposed. An important stage to predict the liquefaction is the prediction of excess pore water pressure at a given point. In general, there are two important methods for soil dynamics analyses, fully coupled effective stress ...
متن کاملEvaluation of Wave Barriers on Ground Vibration Reduction through Numerical Modeling in Abaqus
This paper aims to investigate the train-induced ground vibration and appropriate countermeasures using numerical modeling by Abaqus. First, the effect of appropriate boundary modeling in wave propagation studies is addressed by illustrating the application of nonreflecting boundaries in Abaqus using infinite elements. Second, the propagation of waves in the ground was investigated by applying ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره شماره
صفحات -
تاریخ انتشار 2006