Measurements of Flat-Flame Velocities of Diethyl Ether in Air.
نویسندگان
چکیده
This study presents new adiabatic laminar burning velocities of diethyl ether in air, measured on a flat-flame burner using the heat flux method. The experimental pressure was 1 atm and temperatures of the fresh gas mixture ranged from 298 to 398 K. Flame velocities were recorded at equivalence ratios from 0.55 to 1.60, for which stabilization of the flame was possible. The maximum laminar burning velocity was found at an equivalence ratio of 1.10 or 1.15 at different temperatures. These results are compared with experimental and computational data reported in the literature. The data reported in this study deviate significantly from previous experimental results and are well-predicted by a previously reported chemical kinetic mechanism.
منابع مشابه
Measurements of DME/Air Mixture Burning Velocities by Using Particle Image Velocimetry
The laminar flame speed of Dimethyl Ether (DME)/air mixtures at room temperature and atmospheric pressure were determined experimentally over an extensive range of equivalence ratios, with and without 15% nitrogen dilution, using Particle Image Velocimetry (PIV) and a stagnation flame burner configuration. The laminar flame speeds were determined by linear extrapolation of the measured referenc...
متن کاملمطالعه اثرنوع حلال و خشک نمودن زیست توده بر استخراج لیپید از میکروجلبک نانوکلروپسیس اوکولاتا جهت تولید بیودیزل
Background and Objectives: As a green fuel and environmentally friendly energy, biodiesel has recently attracted much attention and efforts are ongoing to optimizing biodiesel production from microalgae’s. The aim of this study was to determine the appropriate method of dewatering and drying biomass and selecting a suitable organic solvent for extraction lipids from biomass. Materials and Metho...
متن کاملEvaluation of factors affecting on lipid extraction for recovery of fatty acids from Nannochloropsis oculata micro-algae to biodiesel production
Background: This study aimed at determining the appropriate method for dewatering and drying biomass and selecting a suitable organic solvent for lipid extraction. Methods: Nannochloropsis Oculata was cultured in Gillard F/2 medium and after reaching the end of the stationary growth phase, algal biomass was separated from aqueous by centrifuge and dried through three methods: Oven, Air-dried an...
متن کاملOccupational Exposure Rate of Staffs of Bushehr Forensic Medicine Toxicology Lab to Chloroform, Diethyl Ether and Ammonia
Abstract Background and aims: Chloroform, diethyl ether and ammonia are toxic solvents wildly used in forensic labs for preparation and extraction of samples. The staffs of forensic labs experience high levels of exposure to these solvents. Serious health effects have been reported due to exposure to these solvents including hepatotoxicity, neurotoxicity, carcinogenicity and mutagenicity. Ma...
متن کاملTechnical Note
Carbon disulfide is the solvent of choice for eluting adsorption packages prior to analysis by GC/FID. In laboratories which utilize mass selective detectors instead of flame ionization detectors, diethyl ether, a much friendlier solvent, can be used in place of the CS2. No loss of sensitivity occurs, and there is a salutary impact on bench workers' health as well as on the aroma of the fire de...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
- Energy
دوره 43 1 شماره
صفحات -
تاریخ انتشار 2012