Constructing a Low Energy Transfer Between

نویسندگان

  • Jovian Moons
  • Wang Sang Koon
  • Martin W. Lo
  • Jerrold E. Marsden
  • Shane D. Ross
چکیده

There has recently been considerable interest in sending a spacecraft to orbit Europa, the smallest of the four Galilean moons of Jupiter. The trajectory design involved in effecting a capture by Europa presents formidable challenges to traditional conic analysis since the regimes of motion involved depend heavily on three-body dynamics. New three-body perspectives are required to design successful and efficient missions which take full advantage of the natural dynamics. Not only does a three-body approach provide low-fuel trajectories, but it also increases the flexibility and versatility of missions. We apply this approach to design a new mission concept wherein a spacecraft “leap-frogs” between moons, orbiting each for a desired duration in a temporary capture orbit. We call this concept the “Petit Grand Tour.” For this application, we apply dynamical systems techniques developed in a previous paper to design a Europa capture orbit. We show how it is possible, using a gravitional boost from Ganymede, to go from a jovicentric orbit beyond the orbit of Ganymede to a ballistic capture orbit around Europa. The main new technical result is the employment of dynamical channels in the phase space — tubes in the energy surface which naturally link the vicinity of Ganymede to the vicinity of Europa. The transfer ∆V necessary to jump from one moon to another is less than half that required by a standard Hohmann transfer.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Dynamic Analysis of Offshore Wind Turbine Towers with Fixed Monopile Platform Using the Transfer Matrix Method

In this paper, an analytical method for vibrations analysis of offshore wind turbine towers with fixed monopile platform is presented. For this purpose, various and the most general models including CS, DS and AF models are used for modeling of wind turbine foundation and axial force is modeled as a variable force as well. The required equations for determination of wind turbine tower response ...

متن کامل

A New System of Contactless Power Transfer with Low Voltage Stress and Parasitic Capacitors Effect

In this paper, a high frequency contactless power transfer (CPT) system is designed with ∅2 inverter drive. This system works in 30MHz frequency and 380W power with low voltage stress and considers the inductive link parasitic capacitor effect. In the design, we formulated the inverter equations first and then suggested another design for the transmitter and the receiver coils as the energy tra...

متن کامل

Scalings of Inverse Energy Transfer and Energy Decay in 3-D Decaying Isotropic Turbulence with Non-rotating or Rotating Frame of Reference

Energy development of decaying isotropic turbulence in a 3-D periodic cube with non-rotating or rotating frames of reference is studied through direct numerical simulation using GPU accelerated lattice Boltzmann method. The initial turbulence is isotropic, generated in spectral space with prescribed energy spectrum E(κ)~κm in a range between κmin and ...

متن کامل

Numerical Study of Heat Transfer and Aerosol Deposition in a Room Environment with Under-floor or Baseboard Heating Systems

In this study, heat transfer and aerosol deposition in the under-floor and baseboard heating systems have been investigated, numerically. The aim of this study is a comparison between these heating systems. This comparison obtains the optimal heating system with low suspended particles in the air. Computational fluid dynamic with Eulerian-Lagrangian method has been used to simulate fluid and pa...

متن کامل

Optimization of Thermal Conductivity of Al2O3 Nanofluid by Using ANN and GRG Methods

Common heat transfer fluids such as water, ethylene glycol, and engine oil have limited heat transfer capabilities due to their low heat transfer properties. Nanofluids are suspensions of nanoparticles in base fluids, a new challenge for thermal sciences provided by nanotechnology. In this study, we are to optimize and report the effects of various parameters such as the ratio of the thermal co...

متن کامل

Solidification and thermal performance analysis of the low carbon steel during the continuous casting process

The present paper evaluates the effect of the nozzle characteristics on the heat transfer and phase change of the low carbon steel during the continuous casting process. A three-dimensional energy equation and a solidification model are used to drive the governing equation of the phase change and temperature distribution. A linear relation is obtained to predict the temperature-dependent of the...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2002