A Compact Model for Flowrate and Pressure Computation in Micro-fluidic Devices
نویسندگان
چکیده
A compact model to compute flowrate and pressure in micro-fluidic devices is presented. The micro-fluidic flow can be driven by either an applied electric field or by a pressure gradient or both. In the proposed compact model, the complex fluidic network is simplified by using an electrical circuit. The compact model can predict the flowrate, pressure distribution and other basic characteristics in microfluidic channels quickly with good accuracy when compared to detailed numerical simulations.
منابع مشابه
Fluidic Oscillators’ Applications, Structures and Mechanisms – A Review
Enhancement of heat and mass transfer and decrease of energy dissipation are great necessities of the evolution of fluid flow devices. Utilizing oscillatory or pulsatile fluid flow for periodic disturbing of velocity and thermal boundary layers is one of the methods with exciting results. Passive methods of generating oscillatory flow are preferred to active methods because of simplicity, no ne...
متن کاملDesign and Simulation of a Fluidic Micro-Bio-Sensor Based on Resonator Array
In this paper, a fluidic biosensor with possibility to fabricate by Micro-Electro-Mechanical Systems (MEMS) technology is proposed for biomedical mass detection and lab-on-chip applications. This is designed by electromechanical coupling of harmonic micromechanical resonators with harmonic springers as a mechanical resonator array. It can disperse mechanical wave along the array by electrostati...
متن کاملIn-Trim Flight Investigations of a Conceptual Fluidic Thrust-Vectored Unmanned Tail-Sitter Aircraft
The feasibility of using a stand alone Fluidic Thrust-Vectoring (FTV) system for the purpose of longitudinal trim of an unmanned aerial vehicle is the focus of the research presented in this paper. Since the fluidic thrust vectoring requires high pressure secondary air to deflect the engine exhaust gases, this research also provides an analytical toolset for preliminary sizing of a suitable sec...
متن کاملC2lc20956j 1890..1896
We develop a theoretical model for a fluidic current source consisting of a via, a detour channel, and a push-up type micro-valve. The model accurately describes the non-linear behaviour of this type of device, which has been previously measured experimentally. We show how various structural parameters and material properties of the device influence the saturated flow rate and the minimum drivi...
متن کاملEfficient energy based modeling and experimental validation of liquid filling in planar micro-fluidic components and networks.
This paper presents a model that describes how liquid flow fills micro-fluidic components and networks. As an alternative to computational fluid dynamic (CFD) simulations, we use a constrained energy minimization approach. This approach is based on two assumptions that hold in many micro-fluidic devices: (i) The length scales are small, and we consider slow filling rates, hence fluid momentum a...
متن کامل