Optical spectrum based measurement of flotation slurry contents

Recursive multimodel partial least squares estimation of mineral flotation slurry contents using optical reflectance spectra.

In mineral flotation the X-ray fluorescence (XRF) grade measurements of the slurries typically give the most important on-line information on the state of the flotation process. It has been shown that the visual and near-infrared (VNIR) reflectance spectrum measurements of certain mineral slurries can be used to complete the sparse XRF slurry content information. This study focuses on the chemo...

Partial least squares estimation of mineral flotation slurry contents using optical reflectance spectra

Reflectance Spectroscopy in the Analysis of Mineral Flotation Slurries

Effective monitoring and control of a mineral flotation process necessitates accurate and rapid on-line analysis of the slurry flows. Recent development of lightweight and low-cost visible and near-infrared (VNIR) imaging spectrographs has provided new interesting possibilities also in mineral froth and slurry analysis. The intelligent combination of VNIR reflectance spectroscopy with the tradi...

Detection and analysis of oscillations in a mineral flotation circuit

A novel mineral slurry assaying method combining visible and near-infrared reflectance spectroscopy and traditional X-ray fluorescence has recently been developed. The improved method is capable of high-frequency assaying of slurry grades in zinc and copper flotation, thus being able to reveal possible rapid oscillations in the grades. In this study, the new measurements are used to detect osci...

Investigation of Flotation Parameters for Copper Recovery from Enargite and Chalcopyrite Mixed Ore

A flotation pre-treatment study for the separation of enargite (Cu3AsS4) from chalcopyrite (CuFeS2) ores of different origins was investigated in this work. The copper ore bearing enargite mineral contained 5.87mass% As and 16.50mass% Cu while the chalcopyrite bearing ore contained 0.32mass% As and 21.63mass% Cu. The two ore samples were mixed at 7 : 3 (enargite : chalcopyrite) by weight ratio ...