A Low Noise Amplifier Optimized for a GPS Receiver RF Front End

نویسندگان

  • Xiao Feng Dong
  • Craig Jin
  • André van Schaik
چکیده

A cascode LNA was optimized for a GPS receiver radio frequency front end using a 0.18 μm CMOS technology. By careful choice of device geometry, gate and source degeneration inductors, a fully integrated LNA can be optimized to have a low noise figure, a high voltage gain and a wide dynamic range. The optimized LNA has a 1.512 dB noise figure, a –42.05 dB S11, a 20.04 dB voltage gain a –19.82 dB input referred 1-db compression point and a –5.49 dBm third order input intercept point, with a 11.6 mW power consumption.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Design of High Gain, High Reverse Isolation and High Input Matched Narrowband LNA for GPS L1 Band Applications Using 0.18µm Technology

Design of Global Positioning System (GPS) receiver with a low noise amplifier (LNA) in the front end remains a major design requirement for the success of modern day navigation and communication system. Any LNA is expected to meet the requirements like its ability to add the least amount of noise while providing sufficient gain, perfect input and output matching, and high linearity. However, mo...

متن کامل

A 1.57-GHz RF Front-End for Triple Conversion GPS Receiver

A low-power, 1.57-GHz RF front-end for a global positioning system (GPS) receiver has been designed in a 1.0m BiCMOS technology. It consists of a low noise amplifier with 15 dB of gain, a single balanced mixer with 6.3 mS of conversion gm, a Colpitts LC local oscillator, and an emitter coupled logic (ECL) divide-by-eight prescaler. This front-end has a singal sideband (SSB) noise figure of 8.1 ...

متن کامل

CMOS Front-End Circuits of Dual-Band GPS Receiver

A RF front-end chip for a dual-band Global Positioning System (GPS) receiver for L1 and L2 bands is designed using 0.25 μm CMOS technology. All function blocks of the GPS front-end are integrated onto one chip. The low noise amplifier has input matching over a wide frequency range to handle the L1 and L2 bands. This receiver uses a dualband image-reject mixer with the quadrature mixer sharing a...

متن کامل

A SiGe RF Front-End with On-Chip VCO for a GPS Receiver

A GPS direct conversion RF front-end with on-chip VCO fabricated in 0.35μm SiGe BiCMOS technology is presented. The properties of inductively degenerated common-emitter LNA and resistively degenerated Gilbert downconversion mixer are examined. The approximative equations for the front-end DSB-NF and IIP3 are given. By applying the derived formulas, the front-end performance can be readily estim...

متن کامل

RF Front-End IC Simplifies Software GPS Receiver - Application Note - Maxim

This article investigates the basic theory of software-based receivers for L1-band civilian GPS applications, including a discussion of signal acquisition and tracking, and the need for bit synchronization in the receiver. Also included is a brief description of an L1-band GPS receiver, the MAX2741, which serves as a compact and inexpensive RF front-end for the receiver. A similar article appea...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2006