Soviet Research and Development of High-Power Gap Switches
نویسندگان
چکیده
منابع مشابه
Design of power-efficient adiabatic charging circuit in 0.18μm CMOS technology
In energy supply applications for low-power sensors, there are cases where energy should be transmitted from a low-power battery to an output stage load capacitor. This paper presents an adiabatic charging circuit with a parallel switches approach that connects to a low-power battery and charges the load capacitor using a buck converter which operates in continuous conduction mode (CCM). A gate...
متن کاملDesign and Simulation of a New DC Power Supply Based on Dual Bridge Matrix Converter
A conventional high power DC power supply systems consist of a three-phase diode rectifier followed by a high frequency converter to supply loads at regulated DC voltage. These rectifiers draw significant harmonic currents from the utility, resulting in poor input power factor. In this paper, a DC power supply based on dual-bridge matrix converter (DBMC) with reduced number of switches is p...
متن کاملThe Study of Breakdown Voltages for Triggered Spark Gap Switches
This study explains the breakdown mechanism in different triggered spark gap switches. Two different trigger electrode configurations are tested for the switch predischarge operation in a nitrogen laser circuit. The behavior of the breakdown voltage, when a trigger pulse is applied to the trigger electrode, is investigated, and the results are reported. Based on the experimental measurements ne...
متن کاملHigh Gain DC-DC Converter using Active Clamp Circuit (RESEARCH NOTE)
In this paper, a boost converter with a clamp circuit is proposed for high intensity discharge (HID) lamp application. The clamp circuit provides zero voltage turn on for both main and clamp switches. Compared to conventional boost converters, the proposed converter has the following advantages: (i) high voltage gain without suffering from extreme duty ratio, (ii) low stress on the switches and...
متن کاملA New Single-phase Symmetrical Cascade Multilevel Inverter with Low Number of Power Switches
In this paper a new 5-level single phase symmetrical cascade multi-level inverter is proposed. The proposed topology contains combination of unidirectional and bidirectional power switches based on output voltage level number. The number of power switches and withstanding voltage of powers witches were reduced related to the other topologies. This configuration can be extended to the n-level in...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره شماره
صفحات -
تاریخ انتشار 2014