A new settling velocity model to describe secondary sedimentation.
نویسندگان
چکیده
Secondary settling tanks (SSTs) are the most hydraulically sensitive unit operations in biological wastewater treatment plants. The maximum permissible inflow to the plant depends on the efficiency of SSTs in separating and thickening the activated sludge. The flow conditions and solids distribution in SSTs can be predicted using computational fluid dynamics (CFD) tools. Despite extensive studies on the compression settling behaviour of activated sludge and the development of advanced settling velocity models for use in SST simulations, these models are not often used, due to the challenges associated with their calibration. In this study, we developed a new settling velocity model, including hindered, transient and compression settling, and showed that it can be calibrated to data from a simple, novel settling column experimental set-up using the Bayesian optimization method DREAM(ZS). In addition, correlations between the Herschel-Bulkley rheological model parameters and sludge concentration were identified with data from batch rheological experiments. A 2-D axisymmetric CFD model of a circular SST containing the new settling velocity and rheological model was validated with full-scale measurements. Finally, it was shown that the representation of compression settling in the CFD model can significantly influence the prediction of sludge distribution in the SSTs under dry- and wet-weather flow conditions.
منابع مشابه
A new approach to define batch settling curves for analyzing the sedimentation characteristics
The results of batch settling tests (BST) are used to investigate settling behavior of solids suspension, which contribute to sizing thickeners. Conventional methods in analyzing BST on the basis of visual and graphical procedures lead to sub-optimally sized and selected thickeners. A computational approach based on quantitative analysis of BST can be beneficial. About 300 settling experiments ...
متن کاملCFD modelling of sludge sedimentation in secondary clarifiers
We present a CFD model that predicts the sedimentation of activated sludge in a full-scale circular secondary clarifier that is equipped with a suction-lift sludge removal system. The axisymmetric single-phase model is developed using the general-purpose CFD solver FLUENT 6, which uses the finite-volume method. A convection-diffusion equation, which is extended to incorporate the sedimentation ...
متن کاملThe effect of feed ingredients on the settling velocity of feces in Tilapia (Oreochromis niloticus L.)
متن کامل
Investigating the effect of Inlet and Outlet location on Flow field and Sedimentation pattern of a rectangular settling basin using CCHE2D
Water obtained from any source may contain impurities induced by erosion, dissolved minerals, dissolved gases and material produced from organic matter decomposing. If the amount of these substances exceed a certain limit, not only the water would not be potable, but the water containing the material will not be suitable to be used in most applications, or at least before treatment cannot be ap...
متن کاملA New Approach for Obtaining Settling Velocity in a Thickener Using Statistical Regression: A Case Study
In this research work, the parameters affecting the settling velocity within the thickeners were studied by introducing an equivalent shape factor. Several thickener feed samples of different densities including copper, lead and zinc, and coal were prepared. The settling tests were performed on the samples, and the corresponding settling curves were plotted. Using the linear regression analysis...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید
ثبت ناماگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید
ورودعنوان ژورنال:
- Water research
دوره 66 شماره
صفحات -
تاریخ انتشار 2014