Experimental R-curve Behavior in Partially Stabilized Zirconia Using Moiri~ Interferometry

نویسندگان

  • G. B. MAY
  • J. S. EPSTEIN
  • H. OKADA
  • S. N. ATLURI
چکیده

-Moir6 interferometry is employed to study toughening in partially stabilized zirconia (PSZ). Energy to fracture as a function of crack growth curves (R-curves) is derived from mode I compliance calculations and from near tip fitting of the moir6 fringes. The effect of the tetragonal to monoclinic phase transformation in the zirconia is found by comparing the bulk compliance R-curves to the locally derived moir6 R-curve. Localized strain field plots are produced from the moir6 data for the PSZ zirconia. The observed transformation zone height compares favorably with that predicted by Okada et aL [Acta metall. mater. 40, 1421 (1992)] in a companion paper, as does the qualitative nature of the R-curve with predictions by Stump and Budiansky [Acta metall. 37, 3297 (1989)].

برای دانلود رایگان متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

WEAR REESISTANCE OF NANOSTRUCTURED AND CONVENTIONAL YTTRIA-STABILIZED ZIRCONIA COATINGS

Partially stabilized zirconia (PSZ) has been proven to be an excellent candidate as a thermal barrier coating (TBe) for hot sections in, for instance, heat or internal combustion engines and gas turbine parts. The main functions of these coatings are reducing heat losses, reducing fuel consumption, increasing efficiency, and extending durability and life. One of the main problems involved is we...

متن کامل

Gelcasting as a Novel Processing Route to Fabricate Partially Stabilized Zirconia Ceramic Bodies

     Bioinert ceramics, like alumina and zirconia are used mainly for replacements of bones, hip joints and for dental implants. Partially stabilized zirconia ceramics (PSZ or TZP with 3 mol.% or 5 wt.% Y2O3), appear as perspective bioinert ceramics because of their high strength and corrosion resistance. In order to fabricate complex shapes, it is essential to use a near ...

متن کامل

Comparative Study of Plasma Sprayed Yittria and Ceria Stabilized Zirconia Properties

Thermal Barrier Coatings are subjected to spallation and destabilization due to hot corrosion.Recently, Ceria Stabilized Zirconia (CSZ)-based TBCs have been intensively investigated for the YSZreplacement because CSZ has a much lower thermal conductivity and a higher expected thermalexpansion coefficient than those of YSZ. In this research, Yttria stabilized zirconia (YSZ) andceria stabilized z...

متن کامل

Preparation Zirconia Toughened Alumina by Deflocculation-Flocculation Route (TECHNICAL NOTE).

Partially stabilized zirconia (PSZ) agglomerate toughened alumina has been prepared by the "deflocculation-flocculation" technique, using 2 and 3 mol. % Y2O3-doped zirconia powders. Samples containing up to about 30 vol.% zirconia were obtained. The resulting microstructure seems to be mainly influenced by the physical properties of the starting powders, e.g. agglomerate size and the specific s...

متن کامل

A critical comparison of methods for the determination of the aging sensitivity in biomedical grade yttria-stabilized zirconia.

Since the recent failure events of two particular series of zirconia femoral heads for total hip replacement prosthesis, a large decrease in the use of zirconia ceramics for orthopaedic implants has been observed. In spite of the biomedical success of this material during the last 10 years, this decrease in use was required for safety reasons, until the cause of the failures is known. It has be...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2013