Total Dose and Displacement Damage Effects in a Radiation-Hardened CMOS APS
نویسندگان
چکیده
A 512 512 CMOS active pixel sensor (APS) was designed and fabricated in a standard 0.5m technology. The radiation tolerance of the sensor has been evaluated with Co-60 and proton irradiation with proton energies ranging from 11.7 to 59 MeV. The most pronounced radiation effect is the increase of the dark current. However, the total ionizing dose-induced dark current increase is orders of magnitude smaller than in standard devices. It behaves logarithmically with dose and anneals at room temperature. The dark current increase due to proton displacement damage is explained in terms of the nonionizing energy loss of the protons. The fixed pattern noise does not increase with total ionizing dose. Responsivity changes are observed after Co-60 and proton irradiation, but a definitive cause has not yet been established.
منابع مشابه
Gamma-Ray Irradiation Effects on CMOS Image Sensors in Deep Sub-Micron Technology
INTRODUCTION CMOS Active Pixel Sensors (APS) excel in domains that include low power operation and on-chip integration of analog and digital circuitry. Since these sensors are utilized for applications involving the detection of signals as low as a few electrons, radiation tolerance of such devices is of primary concern. All possible radiation effects are usually grouped into three basic types:...
متن کاملTotal Dose Effects on CMOS Active Pixel Sensors
Co irradiations have been carried out on test structures for the development of CMOS Active Pixel Sensors (APS) that can be used in a radiation environment. The basic mechanisms that may cause failure are presented. Ionization induced damage effects such as field leakage currents and dark current increase are discussed in detail. Two different approaches to overcome these problems are considere...
متن کاملDesign and Characterization of Ionizing Radiation-Tolerant CMOS APS Image Sensors up to 30 Mrd (Si) Total Dose
An ionizing radiation-tolerant CMOS active pixel sensor (APS) image sensor test chip was designed employing the physical design techniques of enclosed geometry and -channel guard rings. The test chip was fabricated in a standard 0.35m CMOS process that has a gate-oxide thickness of 7.0 nm. It was irradiated by a -ray source up to a total ionizing radiation dose level of approximately 30 Mrd (Si...
متن کاملRadiation Testing and Evaluation Issues for Modern Integrated Circuits
Changes in modern integrated circuit (IC) technologies have modified the way we approach and conduct radiation tolerance and testing of electronics. These changes include scaling of geometries, new materials, new packaging technologies, and overall speed and device complexity challenges. In this short course section, we will identify and discuss these issues as they impact radiation testing, mo...
متن کاملDesign Techniques for Radiation-Hardened FPGAs
With the RH1280 and RH1020, Actel Corporation introduces radiation-hardened versions of the popular A1280 and A1020 field programmable gate array (FPGA) familes with equivalent gate densities of 8,000 and 2,000 gate array gates, respectively. These products are processed to the QML process flow as defined in MIL-PRF-38535. They are manufactured with a 0.8 micron, two-level metal epitaxial bulk ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره شماره
صفحات -
تاریخ انتشار 2001