The interface in demixed colloid–polymer systems: wetting, waves and droplets{

نویسنده

  • Dirk G. A. L. Aarts
چکیده

Phase transitions in colloid–polymer mixtures have attracted a large amount of attention over the last 20 years (W. C. K. Poon, J. Phys.: Condens. Matter, 2002, 14, R859; R. Tuinier, J. Rieger and C. G. de Kruif, Adv. Colloid Interface Sci., 2003, 103, 1). By comparison, the interfacial tension between the coexisting phases has received little attention. Here, we show that the ultralow interfacial tension in fluid–fluid demixed colloid–polymer systems, which is roughly one million times smaller than in ordinary liquids, manifests itself in a wide variety of interface characteristics and processes. Discussed are the interfacial wetting behaviour close to a hard wall, the thermal capillary waves at the free interface and the process of droplet coalescence and breakup. These subjects can be studied in a single experiment by combining modern soft matter chemistry and laser scanning confocal microscopy. This combination allows a further exploration of a broad range of interface issues.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Life at ultralow interfacial tension: wetting, waves and droplets in demixed colloid-polymer mixtures

Mixtures of colloids and polymers display a rich phase behavior, involving colloidal gas (rich in polymer, poor in colloid), colloidal liquid (poor in polymer, rich in colloid) and colloidal crystal phases (poor in polymer, highly ordered colloids). Recently, the colloidal gas-colloidal liquid interface received considerable attention as well. Due to the colloidal length scale the interfacial t...

متن کامل

Rigid sphere transport through a colloidal gas–liquid interface

In this paper we report on the gravity-driven transport of rigid spheres of various sizes through the fluid–fluid interface of a demixed colloid–polymer mixture. Three consecutive stages can be distinguished: (i) the sphere approaches the interface by sedimenting through the polymer-rich phase, (ii) it is subsequently transported to the colloid-rich phase and (iii) it moves away from the interf...

متن کامل

Depletion-induced phase separation in colloid-polymer mixtures.

Phase separation can be induced in a colloidal dispersion by adding non-adsorbing polymers. Depletion of polymer around the colloidal particles induces an effective attraction, leading to demixing at sufficient polymer concentration. This communication reviews theoretical and experimental work carried out on the polymer-mediated attraction between spherical colloids and the resulting phase sepa...

متن کامل

Wetting, drying, and layering of colloid-polymer mixtures at porous interfaces.

The influence of interface porosity on the wetting properties of colloid-polymer mixtures is studied within density functional theory for the Asakura-Oosawa-Vrij model at the surface of a quenched hard-sphere matrix. While the porosity hardly changes the location of the transition from partial to complete wetting at colloidal bulk gas-liquid coexistence, the onset of wetting, as signaled by the...

متن کامل

A density–functional study of interfacial properties of colloid–polymer mixtures∗

Abstract Interfacial properties of colloid–polymer mixtures are examined within an effective one– component representation, where the polymer degrees of freedom are traced out, leaving a fluid of colloidal particles interacting via polymer–induced depletion forces. Restriction is made to zero, one and two–body effective potentials, and a free energy functional is used which treats colloid exclu...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2006