Slip Mounted Single Point Deformed Structural Skins Slip Mounted Single Point Deformed Structural Skins
ثبت نشده
چکیده
INTRODUCTION Slip Mounted Single Point Deformation expands upon the ideas of single point incremental metal forming, using a 6-axis robotic arm, by exploring the possibilities of how sheet metal can be deformed with minimal support bracing. The goal of this technique and research is to develop controlled methods for fabricating precise, double-curved, structural panels. The slip mounted technique requires mounting a piece of material in the vertical plane while only bracing two edges of the sheet. The material in this method is allowed to stretch, flex and twist during forming unlike in traditional incremental metal forming.
منابع مشابه
Kinematics of Transpressional Deformation Zones in the Urmia Fault Zone, Northwest Iran
Metamorphic and various intrusive rocks in the Urmia area are located in a transpressed active continental margin. These complexes in the Zagros orogen were deformed during an oblique convergence scenario between the Arabian and Sanandaj–Sirjan blocks in NW Iran. The Urmia area contains both NW-SE striking dextral strike-slip and SW verging NE dipping ductile reverse shear fabrics. Ductile shea...
متن کاملStudy of slip in high purity single crystal niobium for accelerator cavities
One of the ultimate goals in particle accelerator cavity design is to establish a model that integrates the grain orientations of an ingot slice, slip activity during deep drawing, and dislocation substructure evolution because of slip system interactions, which governs subsequent recrystallization. In order to understand the slip behavior during deep drawing of large grain Nb, it is fi rst nec...
متن کاملThe recrystallization of copper single crystals deformed at 4.2 K
The deformation of copper single crystals at 4.2 K occurs by a sequence of slip, twinning and slip in the twinned structure. Subsequent annealing of the deformed structures obtained at various points at this sequence of deformation permits the detailed nature of the deformed and recrystallized states to be related in a unique fashion. Material recrystallized from structures obtained prior to th...
متن کاملEvidence of dislocation cross-slip in MAX phase deformed at high temperature
Ti₂AlN nanolayered ternary alloy has been plastically deformed under confining pressure at 900°C. The dislocation configurations of the deformed material have been analyzed by transmission electron microscopy. The results show a drastic evolution compared to the dislocation configurations observed in the Ti₂AlN samples deformed at room temperature. In particular, they evidence out-of-basal-plan...
متن کاملLamination microstructure in shear deformed copper single crystals
We investigate the formation of microscopic patterns in a copper single crystal deformed in a shear experiment. Using high-resolution electron backscatter diffraction (EBSD) imaging, we find a band-like microstructure consisting of confined areas in the sample with rotated lattice. Digital image correlation (DIC) allows us to exactly determine the macroscopic state of deformation of the sample....
متن کامل