Synthesis and Behavior of Cetyltrimethyl Ammonium Bromide Stabilized Zn1+xSnO3+x (0 ≤ x ≤1) Nano-Crystallites

نویسندگان

  • Astrid Placke
  • Ashok Kumar
  • Shashank Priya
چکیده

We report synthesis of cetyltrimethyl ammonium bromide (CTAB) stabilized Zn1+xSnO3+x (0 ≤ x ≤1) nano-crystallites by facile cost-effective wet chemistry route. The X-ray diffraction patterns of as-synthesized powders at the Zn/Sn ratio of 1 exhibited formation of ZnSn(OH)6. Increasing the Zn/Sn ratio further resulted in the precipitation of an additional phase corresponding to Zn(OH)2. The decomposition of these powders at 650°C for 3h led to the formation of the orthorhombic phase of ZnSnO3 and tetragonal SnO2-type phase of Zn2SnO4 at the Zn/Sn ratio of 1 and 2, respectively, with the formation of their mixed phases at intermediate compositions, i.e., at Zn/Sn ratio of 1.25, 1.50 and 1.75, respectively. The lattice parameters of orthorhombic and tetragonal phases were a ~ 3.6203 Å, b ~ 4.2646 Å and c ~ 12.8291Å (for ZnSnO3) and a = b ~ 5.0136 Å and c ~ 3.3055Å (for Zn2SnO4). The transmission electron micrographs revealed the formation of nano-crystallites with aspect ratio ~ 2; the length and thickness being 24, 13 nm (for ZnSnO3) and 47, 22 nm (for Zn2SnO4), respectively. The estimated direct bandgap values for the ZnSnO3 and Zn2SnO4 were found to be 4.21 eV and 4.12 eV, respectively. The ac conductivity values at room temperature (at 10 kHz) for the ZnSnO3 and Zn2SnO4 samples were 8.02 × 10-8 Ω-1 cm-1 and 6.77 × 10-8 Ω-1 cm-1, respectively. The relative permittivity was found to increase with increase in temperature, the room temperature values being 14.24 and 25.22 for the samples ZnSnO3 and Zn2SnO4, respectively. Both the samples, i.e., ZnSnO3 and Zn2SnO4, exhibited low values of loss tangent up to 300 K, the room temperature values being 0.89 and 0.72, respectively. A dye-sensitized solar cell has been fabricated using the optimized sample of zinc stannate photo-anode, i.e., Zn2SnO4. The cyclic voltammetry revealed oxidation and reduction around 0.40 V (current density ~ 11.1 mA/cm2) and 0.57 V (current density- 11.7 mA/cm2) for Zn2SnO4 photo-anode in presence of light.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Synthesis and identification of nanoparticles cobalt (II) bromide by ball mill method

Synthesis, identification and thermal behavior studies of nanoparticles cobalt (II) bromide has been studied in this research. Cobalt (II) bromide was synthesized by planetary high-energy ball mill. The general formula of this compound is CoBr2.6H2O. The synthesized nanoparticles were characterized by Fourier transform infrared spectroscopy and also Size and structure of s...

متن کامل

Synthesis and identification of nanoparticles cobalt (II) bromide by ball mill method

Synthesis, identification and thermal behavior studies of nanoparticles cobalt (II) bromide has been studied in this research. Cobalt (II) bromide was synthesized by planetary high-energy ball mill. The general formula of this compound is CoBr2.6H2O. The synthesized nanoparticles were characterized by Fourier transform infrared spectroscopy and also Size and structure of s...

متن کامل

Hydrothermal Synthesis of Nanoclusters of ZnS Comprised on Nanowires

Cetyltrimethyl ammonium bromide cationic (CTAB) surfactant was used as template for the synthesis of nanoclusters of ZnS composed of nanowires, by hydrothermal method. The structural and morphological studies were performed by using X-ray diffraction (XRD), scanning electron microscopy (SEM) and high resolution transmission electron microscopy (HRTEM) techniques. The synthesized ZnS nanocluster...

متن کامل

Effects of Calcination Temperature on the Synthesis, Chemical Structure, and Magnetic Properties of Nano Crystallites Zinc Ferrite Prepared by Combination of Sol-Gel Auto-Combustion and Ultrasonic Irradiation Techniques

Nanocomposite zinc ferrites were synthesized using glycine-nitrates by sol–gel auto-combustion technique. The influence of calcination temperatures varying from 400 to 900°C on structural and magnetic properties of spinel ZnFe2O4 powders have been investigated. The characterization measurements including X-ray diffraction (XRD), scanning electron microscopy (SEM) and vibrating sample magnetomet...

متن کامل

Chromium Selenide Nanoparticles: Hydrothermal Synthesis in the Presence of a New Selenium Source

Chromium selenide (Cr2Se3) nanoparticles were prepared by hydrothermal method from Cr(NO3)3.9H2O and SeCl4 as precursors. These nanoparticles could be produced simply in the presence of cetyltrimethyl ammonium bromide, sodium dodecyl sulfate and polyethylenglycole 600 (PEG600) and 4ml of hydrazine hydrate (N2H4.H2O) at 180 ˚C for different times. By varying the reducing agent to potassium boroh...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره 11  شماره 

صفحات  -

تاریخ انتشار 2016