RFC 5884 BFD for MPLS
نویسندگان
چکیده
One desirable application of Bidirectional Forwarding Detection (BFD) is to detect a Multiprotocol Label Switching (MPLS) Label Switched Path (LSP) data plane failure. LSP Ping is an existing mechanism for detecting MPLS data plane failures and for verifying the MPLS LSP data plane against the control plane. BFD can be used for the former, but not for the latter. However, the control plane processing required for BFD Control packets is relatively smaller than the processing required for LSP Ping messages. A combination of LSP Ping and BFD can be used to provide faster data plane failure detection and/or make it possible to provide such detection on a greater number of LSPs. This document describes the applicability of BFD in relation to LSP Ping for this application. It also describes procedures for using BFD in this environment.
منابع مشابه
Bidirectional Forwarding Detection (BFD) for MPLS Label Switched Paths (LSPs)
One desirable application of Bidirectional Forwarding Detection (BFD) is to detect a Multiprotocol Label Switching (MPLS) Label Switched Path (LSP) data plane failure. LSP Ping is an existing mechanism for detecting MPLS data plane failures and for verifying the MPLS LSP data plane against the control plane. BFD can be used for the former, but not for the latter. However, the control plane proc...
متن کاملManagement of DiffServ-over-MPLS Transit Networks with BFD/OAM in ForCES Architecture
This paper proposes a management of DiffServ-over-MPLS transit network with BFD(Bidirectional Forwarding Detection)/OAM (operation, administration and maintenance) in ForCES (Forwarding and Control Element Separation) architecture for QoS-guaranteed DiffServ-over-MPLS traffic engineering. The proposed BFD and ForCES functions are implemented on Intel 2400 network processor, where BFD/OAM packet...
متن کاملCommon Interval Support in Bidirectional Forwarding Detection
Bidirectional Forwarding Detection (BFD) requires that messages be transmitted at regular intervals and provides a way to negotiate the interval used by BFD peers. Some BFD implementations may be restricted to only support several interval values. When such BFD implementations speak to each other, there is a possibility of two sides not being able to find a common value for the interval to run ...
متن کاملApplicability of MPLS Transport Profile for Ring Topologies
This document presents an applicability of existing MPLS protection mechanisms, both local and end-to-end, to the MPLS Transport Profile (MPLS-TP) in ring topologies. This document does not propose any new mechanisms or protocols. Requirements for MPLS-TP protection especially for protection in ring topologies are discussed in "Requirements of an MPLS Transport Profile" (RFC 5654) and "MPLS Tra...
متن کاملRFC 5129 ECN for MPLS
RFC 3270 defines how to support the Diffserv architecture in MPLS networks, including how to encode Diffserv Code Points (DSCPs) in an MPLS header. DSCPs may be encoded in the EXP field, while other uses of that field are not precluded. RFC 3270 makes no statement about how Explicit Congestion Notification (ECN) marking might be encoded in the MPLS header. This document defines how an operator ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره شماره
صفحات -
تاریخ انتشار 2010