Conceptual Design of a Dispersion Interferometer Using a Ratio of Modulation Amplitudes
نویسندگان
چکیده
Since a dispersion interferometer is free from mechanical vibrations, it does not need a vibration compensation system even for a probe beam with a short wavelength. This paper describes a new signal processing of the dispersion interferometer using a ratio of modulation amplitudes with a photoelastic modulator. The proposed method is immune to changes in detected signal intensities, thus making the signal processing system simple. Designs of the optical system of the dispersion interferometer for proof of principle, especially specification of a nonlinear optical crystal, are also shown.
منابع مشابه
Conceptual Design of dispersion interferometer using ratio of modulation amplitudes
Since a dispersion interferometer is free from mechanical vibrations, it does not need a vibration compensation system even if a wavelength of a probe beam is short (e.x. infrared and near infrared region). This paper describes a new signal processing of the dispersion interferometer using a ratio of modulation amplitudes with a photoelastic modulator. The proposed method is immune to changes i...
متن کاملDispersion interferometer using modulation amplitudes on LHD (invited).
Since a dispersion interferometer is insensitive to mechanical vibrations, a vibration compensation system is not necessary. The CO2 laser dispersion interferometer with phase modulations on the Large Helical Device utilizes the new phase extraction method which uses modulation amplitudes and can improve a disadvantage of the original dispersion interferometer: measurement errors caused by vari...
متن کاملConceptual Design of Electron Density Measurement System for DEMO-Relevant Helical Plasmas∗)
Electron density measurement remains indispensable to control fueling on a DEMO reactor. For steadystate operation of the DEMO reactor, density measurement should be highly reliable and accurate. A dispersion interferometer and a Faraday polarimeter are free from measurement errors caused by mechanical vibrations. Hence combination of the two diagnostics yields a suitable system for density mea...
متن کاملElectrically switchable cylindrical Fresnel lens based on holographic polymer-dispersed liquid crystals using a Michelson interferometer
Fabricating an electrically switchable cylindrical Fresnel lens based on holographic polymer-dispersed liquid crystals (H-PDLC) using a Michelson interferometer is reported. Simplicity of the method and possibility of fabricating different focal length lenses in a single set up are among the advantages of the method. It is demonstrated that the Fresnel structured zone plate acts as a cylindrica...
متن کاملDesign and Fabrication Process of MTF Phantom CT Scan
Introduction: One of the main steps in the optimization process in diagnostic imaging is the quality control of radiology devices. The usual method of CT scan calibration is used of a phantom. The phantom created a certain weakening for the radiation through which it passes. One of the most suitable methods for quantitative analysis of the resolution and contrast in CT scan im...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره شماره
صفحات -
تاریخ انتشار 2010