Factors affecting broadband acoustic emission measurements of a heterogeneous reaction.
نویسندگان
چکیده
Broadband acoustic emission signals were obtained by attaching a piezoelectric transducer, sensitive up to 750 kHz, to the external wall of a 1 L jacketed glass reactor. Measurements were acquired of itaconic acid particles mixing in toluene; the total area of the acoustic emission signal from 55-500 kHz increased when the particle concentration, particle size or stir rate were increased. Signals at frequencies above 200 kHz were less sensitive to changes in particle size than those at lower frequencies. From calculation of the area of the signal in the range 55-200 kHz as a percentage of the signal area over the range 55-500 kHz, for mixtures of different size ranges of itaconic acid, it was possible to obtain an estimate of the mean particle size of a mixture. The heterogeneous esterification reaction of itaconic acid and 1-butanol was monitored non-invasively. A decrease in the overall acoustic signal area between 60 and 500 kHz was observed as the reaction progressed. Particle size and concentration information were contained in the amplitude of the acoustic emission signal, while the emission frequency yielded information on changes in the mean particle size.
منابع مشابه
On the Use of Acoustic Emission and Digital Image Correlation for Welded Joints Damage Characterization
A series of tests have been conducted to investigate fatigue damage characterization in corroded welded steel plates using structural health monitoring (SHM) techniques. Acoustic Emission (AE) is a non-destructive testing (NDT) technique with potential applications for locating and monitoring fatigue cracks in service. In the present work, AE is implemented to characterize damage during crack e...
متن کاملStudy of the Frictional Surface Damage Using Acoustic Emission Method
In this study, the change at rubbing surfaces has been investigated experimentally using an acoustic emission signal monitoring system. A steel ring is slipped on the surface of a metallic sheet to simulate frictional conditions. The mechanical disturbances caused by the movement of the ring produce stress waves propagating along the sheet surface. The out of plane displacement of the sheet su...
متن کاملHealth Monitoring for Composite under Low-Cycle Cyclic Loading, Considering Effects of Acoustic Emission Sensor Type
Composites have been widely used in the aerospace industry. Due to the requirement of a high safety for such structures, they could be considered for health monitoring. The acoustic emission approach is one of most effective methods for identifying damages in composites. In this article, standard specimens were made from carbon fibers and the epoxy resin, with the [03/902/...
متن کاملDamage Energy Evaluation in [55/-55]9 Composite Pipes using Acoustic Emission Method
In this study, the longitudinal and hoop tensile strengths of an industrial ±55° Glass Reinforced Epoxy (GRE) pipe with eighteen layers as well as the associated failure mechanisms are determined. To obtain the longitudinal and hoop tensile strengths values, three specimens are cut from the studied GRE pipe in each direction. A comparison is done between both the strength values, and the fractu...
متن کاملShallow-water acoustic tomography from angle measurements instead of travel-time measurements.
For shallow-water waveguides and mid-frequency broadband acoustic signals, ocean acoustic tomography (OAT) is based on the multi-path aspect of wave propagation. Using arrays in emission and reception and advanced array processing, every acoustic arrival can be isolated and matched to an eigenray that is defined not only by its travel time but also by its launch and reception angles. Classicall...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
- The Analyst
دوره 131 2 شماره
صفحات -
تاریخ انتشار 2006