Transient Photoconductivity Decay Measurements of Polymer- Terminated Silicon Surfaces
ثبت نشده
چکیده
منابع مشابه
Chemical and electrical passivation of single-crystal silicon(100) surfaces through a two-step chlorination/alkylation process.
Single-crystal Si(100) surfaces have been functionalized by using a two-step radical chlorination-Grignard (R = MgCl, R = CH3, C2H5, C4H9, C6H5, or CH2C6H5) alkylation method. After alkylation, no chlorine was detectable on the surface by X-ray photoelectron spectroscopy (XPS), and the C 1s region showed a silicon-induced peak shift indicative of a Si-C bond. The relative intensity of this peak...
متن کاملMobility - lifetime estimates in amorphous hydrogenated silicon ( a -
Estimates of the majority photocarrier mobility-lifetime (pt) product obtained from time-of-flight transient photoconductivity and from steady-state photo-conductivity are compared. It is shown that in principle both experiments measure the integral of the transient drift mobility; the demonstration is based solely on linear response theory and is independent of the specific microscopic transpo...
متن کاملPhotoconductivity in thin films of a-Ga40SeXTe60-X
2014 Present communication reports on photoconductivity measurements in thin films of Ga40SexTe60-x glasses (x = 20, 30, 40). Temperature dependence of steady state photocurrent and dark current show that dark and steady state photoconductivity are activated processes. Intensity dependence of photocurrent reveals about power law dependence of photocurrent on incident radiation. Also incorporate...
متن کاملMobility and decay kinetics of charge carriers in photoexcited PCBMÕPPV blends
The transient photoconductivity of blends of a highly soluble C60 derivative ~PCBM! and a dialkoxyphenylene-vinylene polymer ~MDMO-PPV! has been studied using the electrodeless flash-photolysis timeresolved microwave conductivity technique ~FP-TRMC!. Films approximately 100 nm thick on a quartz substrate were prepared by spin-coating PCBM/PPV solutions with PCBM weight fractions (WPCBM) from 0....
متن کاملImpact Resistance Enhancement by Adding Core-Shell Particle to Epoxy Resin Modified with Hyperbranched Polymer
A core-shell particle was fabricated by grafting amino-terminated hyperbranched polymer to the surface of silica nanoparticles. The influences of core-shell particle contents on the tensile and impact strength of the epoxy thermosets modified with amino-terminated hyperbranched polymer were discussed in detail. For comparison, core-shell particle was added into the epoxy/polyamide system for to...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره شماره
صفحات -
تاریخ انتشار 2002