Interface Anisotropy and its Effect on Microstructural Evolution During Coarsening

نویسنده

  • Tomoko Sano
چکیده

The driving force for coarsening is provided by the excess interfacial free energy. In a system with isotropic interface energies, classical coarsening theories can predict the evolution of the sizes of spherical crystals. However, if the interfaces are anisotropic, crystal growth and shrinkage may be limited by the surface attachment/detachment rate, the motion of ledges, or the nucleation of new layers. The nucleation limited coarsening theory predicts the development of a transient bimodal grain size distribution consisting of large, growing grains with step producing defects and smaller, perfect grains that act as a source of material for the growing grains. To test the predictions of this theory, a comprehensive study of interfacial structure was conducted on the SrTiO3 system. The study consisted of evaluating the surface energy anisotropy of single phase SrTiO3, determining the grain boundary plane distribution, and characterizing the morphological evolution of the SrTiO3 crystals coarsening in titania rich liquid. The characterization of the evolving microstructure included determining the shape and the grain size distribution. However, the microstructures of the experimental systems only approximate the conditions of the theory and, in reality, because of the relatively high solid fraction, coarsening and grain growth occur simultaneously. To differentiate the mechanisms, the coarsening kinetics of SrTiO3 in 15 volume% titania rich liquid at 1500°C were compared with the grain growth kinetics of SrTiO3 at the same temperature with no intentionally added liquid phase. The results show that while large grains in the coarsening system grew at a much greater rate than any grain in the single-phase system, the small grains in the coarsening system grew more slowly. It appears that the increase in the average size of the small grains can be attributed to grain growth rather than coarsening. The simultaneous existence of a constant number of crystals that coarsen rapidly and a decreasing number of small grains that grow only by grain boundary migration is consistent with the nucleation limited coarsening theory.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Influence of Interface Anisotropy on Grain Growth and Coarsening

! Abstract It has recently become possible to measure the anisotropic distribution of interfaces in polycrystals and composites. Because classical theories for grain growth and coarsening assume isotropic interface properties, they are incapable of explaining how these distributions arise. The purpose of this paper is to review the results of recent experiments, simulations, and theories that d...

متن کامل

Effect of Interface Structure on the Microstructural Evolution of Ceramics

The interface atomic structure was proposed to have a critical effect on the microstructure evolution during sintering of ceramic materials. In liquid-phase sintering, spherical grains show the normal grain growth behavior without exception, while angular grains often grow abnormally. The coarsening process of spherical grains with a disordered or rough interface atomic structure is diffusion-c...

متن کامل

Research on Semisolid Microstructural Evolution of 2024 Aluminum Alloy Prepared by Powder Thixoforming

A novel method, powder thixoforming, for net-shape forming of the particle-reinforced Aluminum matrix composites in semi-solid state has been proposed based on powder metallurgy combining with thixoforming technology. The microstructural evolution and phase transformations have been investigated during partial remelting of the 2024 bulk alloy, prepared by cold pressing of atomized alloy powders...

متن کامل

Effect of NbMo Addition on the Precipitation Behaviour of V Microalloyed Steel during Intercritical Annealing

This paper reports on the precipitation behaviour and microstructural evolution in ~20% cold rolled NbMoV and V single microalloyed low carbon steels during intercritical annealing. The microstructure and precipitation behaviour were studied by optical and scanning/transmission electron microscopy and microanalysis, X-ray diffraction technique and Vickers hardness testing. After intercritical a...

متن کامل

Effect of Heat Input on Microstructural and Mechanical Properties of AISI 304 Welded Joint Via MIG Welding

In this experimental work, AISI 304 was welded via metal inert gas (MIG) welding process with Argon (Ar) as shielding gas. In the present study, AISI 304 was subjected to different heat input using a standard 308L electrode. Weld quality i.e. ultimate tensile strength, toughness, microhardness, and microstructure of AISI 304 were examined. Microstructures of welded joints were studied using sca...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2005