Twenty-watt average output power, picosecond thin-rod Yb:YAG regenerative chirped pulse amplifier with 200 μJ pulse energy

نویسندگان

  • Shinichi MATSUBARA
  • Motoharu TANAKA
  • Masaki TAKAMA
  • Sakae KAWATO
  • Takao KOBAYASHI
چکیده

A high-average power, laser-diode-pumped, picosecond-pulse regenerative chirped pulse amplifier was developed by using the thin-rod Yb:YAG laser architecture. An average output power of 20 W was achieved at a repetition rate of 100 kHz with an output pulse width of 2 ps. 2008 Optical Society of America OCIS codes: (140.3280) Lasers, amplifiers, (140.3615) Lasers, ytterbium, (140.3480) Lasers, diode pumped

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Regenerative spectral and pulse shaping of high average power chirped pulse thin-rod Yb:YAG amplifier

Spectral gain narrowing of high-average power, regenerative chirped pulse thin-rod Yb:YAG amplifier was compensated by the regenerative spectral and pulse shaping technique. An average output power of 18 W was achieved at a repetition rate of 100 kHz with an output pulse width of below 1.2 ps. A wide spectral bandwidth of 2.5 nm was also observed. 2009 Optical Society of America OCIS codes: (1...

متن کامل

20 mJ, 1 ps Yb:YAG Thin-disk Regenerative Amplifier

This is a report on a 100 W, 20 mJ, 1 ps Yb:YAG thin-disk regenerative amplifier. A homemade Yb:YAG thin-disk, Kerr-lens mode-locked oscillator with turn-key performance and microjoule-level pulse energy is used to seed the regenerative chirped-pulse amplifier. The amplifier is placed in airtight housing. It operates at room temperature and exhibits stable operation at a 5 kHz repetition rate, ...

متن کامل

MHz Repetion Rate Yb:YAG and Yb:CaF2 Regenerative Picosecond Laser Amplifiers with a BBO Pockels Cell

We present picosecond Yb:YAG and Yb:CaF2 regenerative laser amplifiers with ultra-high repetition rates in the MHz range. A maximum pulse energy of 40 μJ was obtained at 20 kHz while we achieved around 1 μJ at 1 MHz. We demonstrated a pulse duration of 2.1 ps for Yb:YAG and 4.8 ps for Yb:CaF2 when seeded by a mode-locked Yb:KGW fs-oscillator without pulse stretching or phase compensation.

متن کامل

High-energy, kHz-repetition-rate, ps cryogenic Yb:YAG chirped-pulse amplifier.

We demonstrate amplification of picosecond laser pulses to 40?mJ at a 2?kHz pulse repetition frequency (PRF) from a two-stage cryogenic chirped-pulse Yb:YAG amplifier, composed of a regenerative amplifier (RGA) and a two-pass booster amplifier. The RGA produces 8.2mJ of energy at 2kHz PRF and 13.2mJ at 1kHz PRF with excellent energy stability (approximately 0.3% rms) and beam quality (M(2)<1.1)...

متن کامل

Generation of 287 W, 5.5 ps pulses at 78 MHz repetition rate from a cryogenically cooled Yb:YAG amplifier seeded by a fiber chirped-pulse amplification system.

We generate linearly polarized, 287 W average-power, 5.5 ps pulses using a cryogenically cooled Yb:YAG amplifier at a repetition rate of 78 MHz. An optical-to-optical efficiency of 41% is obtained at 700 W pump power. A 6 W, 0.4 nm bandwidth picosecond seed source at 1029 nm wavelength is constructed using a chirped-pulse fiber amplification chain based on chirped volume Bragg gratings. The com...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2007