Single-inductor multiple-output switching converters with bipolar outputs
نویسندگان
چکیده
A family of single-inductor multiple-outpiit switching converters that provide both positive and negative output voltages is presented. With time multiplexing control, both step-up and step-down bipolar outputs could be achieved. Technical considerations on control loop design and implementing synchronous rectification for single chip converter are discussed. Simulation results are presented to show the validity of the proposed converters.
منابع مشابه
Single-Inductor Multiple-Output Switching Converters
A family of singleinductor multiple-output switching converters is presented. They can be classified into same-type, bipolar, and mixed-type converters. Synchronous rectification and control loop design are discussed, and experimental and simulation results of representative converters are presented to verify the functionality of these converters.
متن کاملSingle-Inductor-Multiple-Output Switching DC-DC Converters
Emerging feature dense portable microelectronic devices pose several challenges, including demanding multiple supply voltages from a single miniaturized power-efficient platform. Unfortunately, the power inductors used in magnetic-based switching converters (which are power efficient) are bulky and difficult to integrate. As a result, single-inductor–multiple-output (SIMO) solutions enjoy popul...
متن کاملSingle-inductor Multiple-output Dc-dc Converters
This chapter deals with the design methodologies to obtain DC-DC converters with multiple outputs and only one inductor. The four possible schemes, buck, boost, and inverting or noninverting buck-boost, are considered. The key specific problems related to the issue are the inductor current switching scheme, the multiple-loops control, the suitable driving of power switches and, accordingly, the...
متن کاملDual-frequency single-inductor multiple-output (DF-SIMO) power converter topology for SoC applications
Modern mixed-signal SoCs integrate a large number of sub-systems in a single nanometer CMOS chip. Each sub-system typically requires its own independent and wellisolated power supply. However, to build these power supplies requires many large off-chip passive components, and thus the bill of material, the package pin count, and the printed circuit board area and complexity increase dramatically...
متن کاملSingle-Inductor Multiple-Output Switching Converters With Time-Multiplexing Control in Discontinuous Conduction Mode
An integrated single-inductor dual-output boost converter is presented. This converter adopts time-multiplexing control in providing two independent supply voltages (3.0 and 3.6 V) using only one 1H off-chip inductor and a single control loop. This converter is analyzed and compared with existing counterparts in the aspects of integration, architecture, control scheme, and system stability. Imp...
متن کامل