The Vertical Emittance in the Atf Damping Ring”
نویسندگان
چکیده
.K. EGAWA, M . KIKUCHI, K. KUBO S. KURODA, K. OIDE, 3; SAKANAKA, N. TERUNUMA, J. URAKAWA KEK; ,National Laboratory for HighEnergy Physics, Tsukuba, lbaraki 305, Japan --_ . . . Abstract The resultspf calculations and simulations of the vertical emittance in the KEK Accelerator Test Facility damping ring are described. Both systematic and random alignment tolerances and a skew correction scheme are presented which lim it the normalized vertical emittance to ~6~ < 4.8 x 10-s m -rad. Finally, the effect of intrabeam scattering on the vertical emittance is calculated.
منابع مشابه
Simulation Studies on the Vertical Emittance Growth at the Existing Atf Extraction Beamline*
Significant beam intensity-dependence of the vertical emittance growth was experimentally observed at the Accelerator Test Facility (ATF) at KEK extraction beamline. This paper presents the simulations of possible vertical emittance growth sources, particularly in the extraction channel, where the magnets are shared by both the ATF extraction beamline and its damping ring. The vertical emittanc...
متن کاملLifetime Measurement of ATF Damping Ring
The purpose of the ATF darnping ring is the development of technologies for .producing a low ernittance bearn required in future linear colliders such as . .-, -_ JLC. The lifetime of the damping ring is very short (typically a few minutes). It is limited by elastic beam-gas scattering along with a srnall dynamic aperture, and by single intra-beam scattering (Touschek effect). The Touschek life...
متن کاملBeam Based Alignment at the Kek-atf Damping Ring*
The damping rings of a future linear collider will have demanding alignment and stability requirements in order to achieve the low vertical emittance necessary for high luminosity. The Accelerator Test Facility (ATF) at KEK has successfully demonstrated the vertical emittance below 5 pm [1] that is specified for the GLC/NLC Main Damping Rings. One contribution to this accomplishment has been th...
متن کاملWire Scanners for Small Emittance Beam Measurement in Atf
The wire scanners are used for a measurement of the very small beam size and the emittance in Accelerator Test Facility (ATF). They are installed in the extraction beam line of ATF damping ring. The extracted beam emittance are εx=1.3x10 m.rad, εy=1.7x10 m.rad with 2x10 electrons/bunch intensity and 1.3GeV energy[1]. The wire scanners scan the beam by a tungsten wire with beam repetition 0.78Hz...
متن کاملBeam Based Alignment at the Kek Accelerator Test Facility
The KEK Accelerator Test Facility (ATF) damping ring is a prototype low emittance source for the NLC/JLC linear collider. To achieve the goal normalized vertical emittance γεy = 20 nm-rad, magnet placement accuracy better than 30 μm must be achieved. Accurate beam-based alignment (BBA) is required. The ATF arc optics uses a FOBO cell with two horizontally focusing quadrupoles, two sextupoles an...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره شماره
صفحات -
تاریخ انتشار 1992