Effects of gasket on coupled plastic flow and strain-induced phase transformations under high pressure and large torsion in a rotational diamond anvil cell
نویسندگان
چکیده
Combined plastic flow and strain-induced phase transformations (PTs) under high pressure in a sample within a gasket subjected to three dimensional compression and torsion in a rotational diamond anvil cell (RDAC) are studied using a finite element approach. The results are obtained for the weaker, equal-strength, and stronger high-pressure phases in comparison with low-pressure phases. It is found that, due to the strong gasket, the pressure in the sample is relatively homogenous and the geometry of the transformed zones is mostly determined by heterogeneity in plastic flow. For the equal-strength phases, the PT rate is higher than for the weaker and stronger high-pressure phases. For the weaker high-pressure phase, transformation softening induces material instability and leads to strain and PT localization. For the stronger high-pressure phase, the PT is suppressed by strain hardening during PT. The effect of the kinetic parameter k that scales the PT rate in the strain-controlled kinetic equation is also examined. In comparison with a traditional diamond anvil cell without torsion, the PT progress is much faster in RDAC under the same maximum pressure in the sample. Finally, the gasket size and strength effects are discussed. For a shorter and weaker gasket, faster plastic flow in radial and thickness directions leads to faster PT kinetics in comparison with a longer and stronger gasket. The rates of PT and plastic flows are not very sensitive to the modest change in a gasket thickness. Multiple experimental results are reproduced and interpreted. Obtained results allow one to design the desired pressure-plastic strain loading program in the experiments for searching new phases, reducing PT pressure by plastic shear, extracting kinetic properties from experiments with heterogeneous fields, and controlling homogeneity of all fields and kinetics of PTs. Disciplines Aerospace Engineering | Structures and Materials Comments This article is published as Feng, Biao, and Valery I. Levitas. "Effects of gasket on coupled plastic flow and strain-induced phase transformations under high pressure and large torsion in a rotational diamond anvil cell." Journal of Applied Physics 119, no. 1 (2016): 015902. doi: 10.1063/1.4939488. Posted with permission. This article is available at Iowa State University Digital Repository: http://lib.dr.iastate.edu/aere_pubs/90 Effects of gasket on coupled plastic flow and strain-induced phase transformations under high pressure and large torsion in a rotational diamond anvil cell Biao Feng, and Valery I. Levitas Citation: Journal of Applied Physics 119, 015902 (2016); View online: https://doi.org/10.1063/1.4939488 View Table of
منابع مشابه
Strain-induced phase transformations under high pressure and large shear in a rotational diamond anvil cell: Simulation of loading, unloading, and reloading
Coupled plastic flow and strain-induced phase transformations (PTs) under high pressure and large plastic shear in a micron scale sample under loading, unloading, and reloading in a rotational diamond anvil cell (RDAC) are studied in detail, utilizing finite element approach. A plastic strain-controlled, pressuredependent kinetic equation, which describes strain-induced PTs, is used. The effect...
متن کاملCoupled phase transformations and plastic flows under torsion at high pressure in rotational diamond anvil cell: Effect of contact sliding
A three-dimensional large-sliding contact model coupled with strain-induced phase transformations (PTs) and plastic flow in a disk-like sample under torsion at high pressure in rotational diamond anvil cell (RDAC) is formulated and studied. Coulomb and plastic friction are combined and take into account variable parameters due to PT. Results are obtained for weaker, equal-strength, and stronger...
متن کاملStrain-induced phase transformation under compression in a diamond anvil cell: Simulations of a sample and gasket
Combined high pressure phase transformations (PTs) and plastic flow in a sample within a gasket compressed in diamond anvil cell (DAC) are studied for the first time using finite element method. The key point is that phase transformations are modelled as strain-induced, which involves a completely different kinetic description than for traditional pressure-induced PTs. The model takes into acco...
متن کاملModeling and simulation of strain-induced phase transformations under compression and torsion in a rotational diamond anvil cell
Strain-induced phase transformations (PTs) under compression and torsion in rotational diamond anvils are simulated using a finite-element approach. Results are obtained for three ratios of yield strengths of lowpressure and high-pressure phases and are compared with those for the compression without torsion from Levitas and Zarechnyy Phys. Rev. B 82 174123 (2010). Various experimental effects ...
متن کاملCoupled plastic flow and phase transformation under compression of materials in a diamond anvil cell: Effects of transformation kinetics and yield strength
The large-strain problem on phase transformations (PTs) under compression in a diamond anvil cell is studied in detail using the finite-element method. The combined effect of transformation kinetics and ratios of the yield strengths of lowand high-pressure phases is examined. Some experimental phenomena (e.g., plateaus in pressure distribution and plasticflow to the center of a sample) are repr...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره شماره
صفحات -
تاریخ انتشار 2016