Comparison measurements of 0:45 radiance factor and goniometrically determined diffuse reflectance.

نویسندگان

  • Silja Holopainen
  • Farshid Manoocheri
  • Erkki Ikonen
  • Kai-Olaf Hauer
  • Andreas Höpe
چکیده

A comparison between the absolute gonioreflectometric scales at the Helsinki University of Technology (TKK) and the Physikalisch-Technische Bundesanstalt (PTB) has been accomplished. Six different reflection standards were measured for their 0:45 spectral radiance factor between 250 and 1650 nm in 10 nm intervals. Also, the 0:d reflectance factor between 400 and 1600 nm in 100 nm intervals was determined from goniometric reflectance measurements over polar angles with subsequent integration within the hemisphere above the sample. Goniometric comparisons covering such an extensive wavelength range and also several different sample materials are rarely implemented. For all but one sample, the difference between the results obtained at the TKK and the PTB was, with the exception of a couple of measurement points, within the expanded uncertainty (k = 2) of the comparison at least up to a wavelength of 1400 nm. All differences between the measurement results can be understood, except for one translucent sample in the visible wavelength range. The effect of sample translucency was found to be significant in the NIR wavelength region. Also, a general tendency of an increase of the TKK values relative to the PTB values in the UV region was observed. Possible causes for this phenomenon are discussed.

برای دانلود رایگان متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

DIFFUSE REFLECTANCE MEASUREMENTS FROM DIFFERENT SURFACES

Relative diffuse reflection measurements from the original and ground surfaces using a He-Ne laser are reported. The intensity measurements for the metallic, transparent dielectric, matte plastic surfaces and colored papers are presented. Our results indicate that among metallic surfaces tested, aluminum has the highest diffuse reflectance; while the original stainless steel surface shows the l...

متن کامل

Reduction of skylight reflection effects in the above-water measurement of diffuse marine reflectance.

Reflected skylight in above-water measurements of diffuse marine reflectance can be reduced substantially by viewing the surface through an analyzer transmitting the vertically polarized component of incident radiance. For maximum reduction of effects, radiometric measurements should be made at a viewing zenith angle of approximately 45 degrees (near the Brewster angle) and a relative azimuth a...

متن کامل

Sensitivity Analysis and Error Analysis of Reflectance Based Vicarious Calibration with Estimated Aerosol Refractive Index and Size Distribution Derived from Measured Solar Direct and Diffuse Irradiance as well as Measured Surface Reflectance

Sensitivity analysis and error of reflectance based vicarious calibration with estimated aerosol refractive index and size distribution derived from measured solar direct and diffuse irradiance as well as measured surface reflectance is conducted for solar reflective channels of mission instruments onboard remote sensing satellites. Through these error analyses, it is found that the most influe...

متن کامل

Development of a Model to Correct Multi-view Angle above Water Measurements for the Analysis of the Bidirectional Reflectance of Coral and Other Reef Substrates

Spectral reflectance characteristics of substrates in a coral reef environment are often measured in the field by viewing a substrate at nadir. However, viewing a substrate from multiple angles would likely result in different spectral characteristics for most coral reef substrates and provide valuable information on structural properties. To understand the relationship between the morphology o...

متن کامل

Spectrodirectional Field and Laboratory Measurements of an Artificial Target

Spectrodirectional experiments with goniometer systems are only able to observe approximations of truly directional surface reflectance properties (BRDF). The directly observed quantity in field experiments is called hemispherical directional reflectance factor (HDRF), corresponding to hemispherical illumination, which depends on the atmospheric conditions, and directional observation. Laborato...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

عنوان ژورنال:
  • Applied optics

دوره 48 15  شماره 

صفحات  -

تاریخ انتشار 2009