RFC 5852 RSVP - TE Ext for MP 2 CP LSP Handover April
نویسندگان
چکیده
In a transport network scenario, Data Plane connections controlled by either a Generalized Multiprotocol Label Switching (GMPLS) Control Plane (Soft Permanent Connections SPC) or a Management System (Permanent Connections PC) may independently coexist. The ability of transforming an existing PC into an SPC and vice versa -without actually affecting Data Plane traffic being carried over it -is a requirement. The requirements for the conversion between permanent connections and switched connections in a GMPLS Network are defined in RFC 5493.
منابع مشابه
RSVP-TE Signaling Extension for LSP Handover from the Management Plane to the Control Plane in a GMPLS-Enabled Transport Network
In a transport network scenario, Data Plane connections controlled by either a Generalized Multiprotocol Label Switching (GMPLS) Control Plane (Soft Permanent Connections SPC) or a Management System (Permanent Connections PC) may independently coexist. The ability of transforming an existing PC into an SPC and vice versa -without actually affecting Data Plane traffic being carried over it -is a...
متن کاملFast Reroute Extensions to RSVP-TE for LSP Tunnels
Fast Reroute Extensions to RSVP-TE for LSP Tunnels Status of This Memo This document specifies an Internet standards track protocol for the Internet community, and requests discussion and suggestions for improvements. Please refer to the current edition of the "Internet Official Protocol Standards" (STD 1) for the standardization state and status of this protocol. Distribution of this memo is u...
متن کاملREEQOS: An RSVP-TE approach for the End-to-End QoS provisioning within MPLS Domains
This paper exposes a new approach, denoted REEQOS, for supporting QoS both in intra and interdomain, generally named autonomous system (AS)[RFC 1771]. This approach is based firstly on MPLS technology and uses RSVP-TE extension (RFC 3209) for establishing two kinds of Label switched paths: I-LSP (Internal LSP) within every AS and E-LSP (External LSP) for inter AS routing. RSVP-TE is used in a l...
متن کاملRFC 5420 Attributes for MPLS LSPs Using RSVP - TE February 2009
Multiprotocol Label Switching (MPLS) Label Switched Paths (LSPs) may be established using the Resource Reservation Protocol Traffic Engineering (RSVP-TE) extensions. This protocol includes an object (the SESSION_ATTRIBUTE object) that carries a Flags field used to indicate options and attributes of the LSP. That Flags field has eight bits, allowing for eight options to be set. Recent proposals ...
متن کاملRSVP-TE Extensions in Support of End-to-End Generalized Multi-Protocol Label Switching (GMPLS) Recovery
Status of This Memo This document specifies an Internet standards track protocol for the Internet community, and requests discussion and suggestions for improvements. Please refer to the current edition of the "Internet Official Protocol Standards" (STD 1) for the standardization state and status of this protocol. Distribution of this memo is unlimited. Abstract This document describes protocol...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره شماره
صفحات -
تاریخ انتشار 2010