Can electron multipacting explain the pressure rise in a cold bore superconducting undulator?
نویسندگان
چکیده
Preliminary studies performed with the cold bore superconducting undulator installed in the ANKA (Angstrom source Karlsruhe) storage ring suggest that the beam heat load is mainly due to the electron wall bombardment. Electron bombardment can both heat the cold vacuum chamber and induce an increase in the pressure because of gas desorption. In this contribution we compare the measurements of the pressure in a cold bore performed in the electron storage ring ANKA with the predictions obtained using the equations of gas dynamic balance in a cold vacuum chamber exposed to synchrotron radiation and electron bombardment. The balance results from two competing effects: the photon and electron stimulated desorption of the gas contained in the surface layer of the chamber wall and of the gas cryosorbed, and the cryopumping by the cold surface. We show that photodesorption alone cannot explain the experimental results and that electron multipacting is needed to reproduce the observed pressure rise. Electron bombardment can at the same time explain the observed beam heat load.
منابع مشابه
Beam Heat Load and Pressure in the Superconducting Undulator Installed at ANKA
A superconducting undulator is installed in the ANKA (ANgstrom source KArlsruhe) storage ring since March 2005. The beam heat load and pressure on the cold bore have been analysed in the first two years of operation, during which the undulator was operated mainly with open gap. We report here on a larger statistics of beam heat load and pressure data collected in the last years with the undulat...
متن کاملLimitations due to Electron-Cloud Heat Load for the LHC and its Upgrade
In the LHC beam pipe, an electron cloud can build up due to photoemission from synchrotron radiation and via a beam-induced multipacting process. This electron cloud gives rise to an additional heat load on the beam screen which protects the cold bore of the superconducting magnets. The heat load from the electron cloud depends on beam parameters such as the bunch intensity, the number of bunch...
متن کاملInitial Studies of Electro~gne~c Shower Energy Deposition in Small-bore Superconducting Undulator Structures in Linac Environments*
One of the more promising technologies for developing minimal-length insertion devices for linac-driven, single-pass Free Electron Lasers (FELs) operating in the x-ray range is based on the use of superconducting (SC) materials. Despite its advantage of minimal length, however, SC technology can present difficulties for insertion device design’and operation. One critical problem, as obsened, e....
متن کاملInternational Committee for Future Accelerators
Dedicated electron cloud diagnostics developed at the Advanced Photon Source (APS) enabled for the first time detailed characterization of the electron cloud (EC) properties in a highintensity positron and electron storage ring. From in situ measurements of the electron flux and energy distribution at the vacuum chamber wall, electron cloud production mechanisms and details of the beam-cloud in...
متن کاملA Simulation Study of Electron-Cloud Instability and Beam-Induced Multipacting in the LHC
In the LHC beam pipe, photoemission and secondary emission give rise to a quasi-stationary electron cloud, which is established after a few bunch passages. The response of this electron cloud to a transversely displaced bunch resembles a short-range wake eld and can cause a fast instability. In addition, beaminduced multipacting of the electrons may lead to an enhanced gas desorption and an ass...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره شماره
صفحات -
تاریخ انتشار 2010