Peak-to-Average Power Ratio Performance Analysis for Orthogonal Chirp Division Multiplexing Multicarrier Systems Based on Discrete Fractional Cosine Transform

In doubly selective fading channels, the orthogonal frequency division multiplexing (OFDM) multicarrier system may fail. Chirp like basis (fractional Fourier transformfractional cosine transform) may be used instead of complex exponential basis in this case to improve the system performance. However, in multicarrier transmission, the high peak to average power ratio (PAPR) of the transmitted signal is one of the difficult problems that face both the chirp and the exponential basis. In this paper, an evaluation for the PAPR performance of a multicarrier system based on the fractional cosine transform (FrCT) is introduced and then compared with DFrFT and FFT. Moreover, applying the SLAM technique over these systems is provided to understand the behaviour of these systems when applying SLAM. Simulations verify that this system obtains a better PAPR performance. Moreover, further PAPR reduction can be gained using the well-known PAPR reduction methods. Moreover, applying SLAM technique improves the performance of γ (dB) by 4 dB to 5 dB and all systems become as competitive to each other when SLAM is applied. Finally, BER performance comparison among OFDM, Discrete Cosine Transform MCM (DCTMCM), Discrete Hartley Transform MCM (DHT-MCM), DFrFT-OCDM and DFrCTOCDM MCM systems was done by means of simulation over 100,000 multicarrier blocks for each one and showed that our proposed scenario gave the best performance.