Design Considerations and Advances in Portable Power Battery Chargers
نویسنده
چکیده
Battery-charger demands have changed from a simple stand-alone charger to an embedded charger and power source for the system. This topic provides some insight into the many new issues the designer should consider when designing either a linear or a switching regulator. Common transient issues caused by hot plugging/unplugging the adapter or system load during operation are presented. Problems and solutions surrounding use of a stand-alone charger to charge a battery with a system load in parallel are discussed along with the optimal solution for powering system loads.
منابع مشابه
Design of a wireless charging system with a phase-controlled inverter under varying parameters
Class-D full bridge is the most common inverter topology at the primary side for wireless electric vehicles (EVs) charging systems. This study takes a novel topology of a phase-controlled inverter as the power amplifier and puts it in a context of the whole charging system. The proposed inverter topology regulates the charging power through adjusting the phase-shift angle among phases with a co...
متن کاملAn Experimental and Comparative Analysis of the Battery Charge Controllers in Off-Grid PV Systems
The study of the battery charge process as the only power storage agent in off-grid systems is of significant importance. The battery charge process has different modes, and the battery in these modes is dependent on the amount of charge. In order to charge the battery in off-grid systems, two charge controllers including Pulse Width Modulation (PWM) and Maximum Power Point Tracker (MPPT) are c...
متن کاملA Power Balance Aware Wireless Charger Deployment Method for Complete Coverage in Wireless Rechargeable Sensor Networks
Traditional sensor nodes are usually battery powered, and the limited battery power constrains the overall lifespan of the sensors. Recently, wireless power transmission technology has been applied in wireless sensor networks (WSNs) to transmit wireless power from the chargers to the sensor nodes and solve the limited battery power problem. The combination of wireless sensors and wireless charg...
متن کاملExperimental measurements about harmonic current mitigation of electric vehicle battery chargers
The expected high penetration of battery chargers for electric vehicles (EV) in electric networks is foreseen as a potential problem for power quality. Battery chargers are nonlinear devices that inject harmonic currents and pollute network voltages. Thus, their harmonic emissions must be analyzed and reduced by harmonic mitigation techniques to avoid future problems. This paper analyzes and re...
متن کاملImproving Fast Charging Methods Using Genetic Algorithm and Coordination between Chargers in Fast Charging Station of Electric Vehicles in Order to Optimal Utilization of Power Capacity of Station
Fast charging stations are one of the most important section in smart grids with high penetration of electric vehicles. One of the important issues in fast chargers is choosing the proper method for charging. In this paper, by defining an optimization problem with the objective of reducing the charging time, the optimal charging levels are obtained using a multi-stage current method using a gen...
متن کامل