Gasdynamic Simulation of Aerosol Deposition Method
نویسندگان
چکیده
The gas flow of aerosol deposition method (ADM) is simulated using the method of computational fluid dynamics (CFD), and the velocity of particles flowing in the gas flow is also calculated by numerically integrating Newton’s second law of motion. The process gas is nitrogen and the particle material is Pb(Zr,Ti)O3 (PZT). The calculated particle velocities are compared with experimental results obtained by using a slit-cell method (SCM), which may disturb the gas-particle jet-flow of ADM during the measurement of particle velocity. The comparison of calculated and measured results reveals that the SCM can cause unexpected measurement error due to disturbing the gas-particle jet-flow caused by the stagnation pressure exceeding a certain value. [doi:10.2320/matertrans.47.1620]
منابع مشابه
Purely Gasdynamic Multidimensional Indirect Detonation Initiation Using Localized Acoustic Timescale Power Deposition
A “purely gasdynamic” indirect detonation initiation process is presented that can be independent of diffusion, viscosity and turbulence, and does not require direct initiation. In this process, energy is deposited into a finite volume of fluid in an amount of time that is similar to the acoustic timescale of the fluid volume. Highly resolved two-dimensional simulations show that the artificial...
متن کاملNumerical Study of Heat Transfer and Aerosol Deposition in a Room Environment with Under-floor or Baseboard Heating Systems
In this study, heat transfer and aerosol deposition in the under-floor and baseboard heating systems have been investigated, numerically. The aim of this study is a comparison between these heating systems. This comparison obtains the optimal heating system with low suspended particles in the air. Computational fluid dynamic with Eulerian-Lagrangian method has been used to simulate fluid and pa...
متن کاملEulerian Lagrangian Simulation of Particle Capture and Dendrite Formation on Binary Fibers
The capture efficiency of the small aerosol particle is strongly influenced by the structure of fibrous layers. This study presents particle deposition and dendrite formation on different arrangements of binary fibers. 2-D numerical simulation is performed using the open source software of OpenFOAM. In the instantaneous filtration of a single fiber, obtained results are in good agreement with th...
متن کاملDispersion and Deposition of Micro Particles over Two Square Obstacles in a Channel via Hybrid Lattice Boltzmann Method and Discrete Phase model
Dispersion and deposition of aerosol particles over two square cylinders confined in a channel in laminar unsteady vortical flow were investigated numerically. Lattice Boltzmann method was used to calculate fluid characteristics and modify Euler method was employed as Lagrangian particle tracing procedure to obtain particle trajectories. Drag, Saffman lift, gravity, buoyancy and Brownian motion...
متن کاملDeposition of Various Shapes Particles on a Rough Surface in Turbulent Flow
An experiment set-up is used to study wall deposition rate of particles on a rough surface in a turbulent channel flow. Deposition velocities for three classes of particles, namely, spherical glass particles, irregular shape polymer particles, and fibrous silicon particles are studied. The particle concentration at the test section was measured with the aid of an isokinetic probe in conjunction...
متن کامل