Optimal production and shipment models for a single-vendor-single-buyer integrated system

This paper develops a more general production-inventory model for a single-vendor–single-buyer integrated system. Unlike the hitherto existing production-inventory models for the vendor–buyer system, the present model neither requires the buyer’s unit holding cost greater than the vendor’s nor assumes the structure of shipment policy. Secondly, the model is extended to the situation with shortages permitted, based on shortages being allowed to occur only for the buyer. Thirdly, the paper also presents a corresponding production-inventory model for a deteriorating item for the integrated system. The solution procedures are provided for finding the optimal production and shipment policies and illustrated with numerical examples. Three significant insights are shown: (1) no matter whether the buyer’s unit holding cost is greater than the vendor’s or not, the present model always performs best in reducing the average total cost as compared to the hitherto existing models; (2) if the buyer’s unit holding cost is less than the vendor’s, the optimal shipment policy for the integrated system will only comprise shipments with successive shipment sizes increasing by a fixed factor. It is different from that obtained by Hill [Hill, R.M., 1999. The optimal production and shipment policy for the single-vendor single-buyer integrated production-inventory problem. International Journal of Production Research 37, 2463–2475] for the opposite case; (3) when designing a single-vendor–single-buyer integrated system, making the buyer’s unit holding cost lower than the vendor’s is more beneficial to the system if shortages are not permitted to occur; otherwise it just reverses. 2006 Elsevier B.V. All rights reserved.