Preparation of a Carbon Doped Tissue-Mimicking Material with High Dielectric Properties for Microwave Imaging Application

نویسندگان

  • Siang-Wen Lan
  • Min-Hang Weng
  • Ru-Yuan Yang
  • Shoou-Jinn Chang
  • Yaoh-Sien Chung
  • Tsung-Chih Yu
  • Chun-Sen Wu
چکیده

In this paper, the oil-in-gelatin based tissue-mimicking materials (TMMs) doped with carbon based materials including carbon nanotube, graphene ink or lignin were prepared. The volume percent for gelatin based mixtures and oil based mixtures were both around 50%, and the doping amounts were 2 wt %, 4 wt %, and 6 wt %. The effect of doping material and amount on the microwave dielectric properties including dielectric constant and conductivity were investigated over an ultra-wide frequency range from 2 GHz to 20 GHz. The coaxial open-ended reflection technology was used to evaluate the microwave dielectric properties. Six measured values in different locations of each sample were averaged and the standard deviations of all the measured dielectric properties, including dielectric constant and conductivity, were less than one, indicating a good uniformity of the prepared samples. Without doping, the dielectric constant was equal to 23 ± 2 approximately. Results showed with doping of carbon based materials that the dielectric constant and conductivity both increased about 5% to 20%, and the increment was dependent on the doping amount. By proper selection of doping amount of the carbon based materials, the prepared material could map the required dielectric properties of special tissues. The proposed materials were suitable for the phantom used in the microwave medical imaging system.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Fabrication of Silver doped Buckypaper and Investigation of its Properties

Microwave absorbing property of composites containing Ag nanoparticles filled multiwalled carbon nanotube buckypaper (Ag-BP) has been investigated. Buckypaper doped with silver was prepared by direct dispersion and filtration method. From the low temperature resistivity measurement it was found that increasing doping level decreases the electrical conductivity of the buckypaper. 30 wt. % and 40...

متن کامل

Simple Method for the Preparation of Fe3O4/MWCNT Nanohybrid as Radar Absorbing Material (RAM)

We have successfully prepared Fe3O4/MWCNT nanohybrid with a very simple and economical method. Multi-Walled Carbon NanoTubes (MWCNT) encapsulated with Fe3O4 nanoparticles were synthesized via pyrolyzing of ferrocene. The sample was characterized with XRD, TEM and Vibrating Sample Magnetometer (VSM). Also, Permeability (µ) and Permittivity (ε) were...

متن کامل

Synthesis of Carbon Nanotubes on Cerium-Substituted Barium Ferrite Substrate by Chemical Vapor Deposition for Preparation of a Microwave Absorbing Nanocomposite

In this research, at first, Ce-substituted barium ferrite, BaCe0.2Fe11.8O19 was prepared via the sol-gel method as a substrate and then Carbon NanoTubes (CNTs) was synthesized on the surface of the substrate by Chemical Vapor Deposition (CVD) technique. The structure, morphology, and electromagnetic performance of the synthesized nanocompos...

متن کامل

Tissue-mimicking phantom materials for narrowband and ultrawideband microwave applications.

We propose and characterize oil-in-gelatin dispersions that approximate the dispersive dielectric properties of a variety of human soft tissues over the microwave frequency range from 500 MHz to 20 GHz. Different tissues are mimicked by selection of an appropriate concentration of oil. The materials possess long-term stability and can be employed in heterogeneous configurations without change i...

متن کامل

Effect of Calcination Kinetics and Microwave Sintering Parameters on Dielectric and Peizo-Electric Properties of(K0.5Na0.5) NBO3 Ceramics

An efficient solid-state approach was established to synthesize (K0.5Na0.5) NbO3 ceramics using calcination kinetics and microwave assisted sintering. Milling of carbonate and oxide raw materials were carried out for 15h to obtain homogeneous nano particles. The crystallite size of 5.30 nm was obtained for the KNN system after calcination through optimized parameters and observed to be stoichio...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره 9  شماره 

صفحات  -

تاریخ انتشار 2016