Excess heat and nuclear products by D2O/Pd electrolysis and multibody fusion
نویسندگان
چکیده
An excess heat of 100 W/cc level, 1.7 times the input power in average, and 160 MJ in total was observed for about two months by the L-H mode pulse electrolysis of a D2O/Pd cell with plane-symmetric configuration of D-loading into the Pd cathode. Very weak neutron emission was detected to show an inversely proportional correlation to the excess heat variation. To explain the observed anomalous results including our past results, the theoretical model of competing multibody deuteron fusions in transient PdDx lattice has been extended. It can explain most experimental results. Cold fusion may be the multibody fusion of hydrogen isotopes in the metal lattice.
منابع مشابه
Primary Calorimetric Results on Closed Pd|d2o Electrolysis Systems by Calvet Calorimetry
Anomalous heat absorption was observed in a closed Pd|D2O electrolysis system by Calvet calorimetry. The average excess power was – 14.6 mW over 105 hours period, which corresponds to a volume excess power of – 10.3 W/cm Pd and heat absorption of 3.81 MJ/cm Pd or 350 eV/atom Pd.
متن کاملCharacteristics of Excess Heat in Pd|D2O+D2SO4 Electrolytic Cells Measured by Seebeck Envelope Calorimetry
Pre-electrolysis at the boiling point in open Pd|D2O cells is an effective method to activate a palladium cathode, which can produce excess power in subsequent electrolysis in closed systems for several months. The reproducibility is 23/45. Another characteristic of excess heat is the apparent resistance of electrolytic cell changes irreversibly with temperature.
متن کاملElectrochemical Calorimetric Studies of the Cold Fusion Effect
Several types of calorimetric cell designs were used in attempts to measure excess enthalpy during the electrolysis of LiOD/D2O using palladium cathodes. Control experiments were run by using light water in place of D2O or by using platinum cathodes in place of palladium. Initial experiments using thin palladium cathodes of an unknown purity gave no significant differences between the Pd/D2O ce...
متن کاملEXCESS HEAT REPRODUCIBILITY AND EVIDENCE OF ANOMALOUS ELEMENTS AFTER ELECTROLYSIS IN Pd|D2O+H2SO4 ELECTROLYTIC CELLS
Electrolyte temperature is a key factor in excess heat production using Pd|D2O+H2SO4 electrolytic cells. Best results are obtained when the electrolyte temperature is close to the boiling point. Stable excess heat is generated by events on or near the Pd cathode surface. In addition to the stable excess heat, heat bursts are sometimes observed. These occurred most frequently in experiments usin...
متن کاملCorrelation of excess power and helium production during D2O and H2O electrolysis using palladium cathodes
A critical issue in determining whether or not the anomalous effects that occur during D2O electrolysis are of nuclear origin is the measurement of nuclear products in amounts sufficient to explain the rate of excess enthalpy generation. Calorimetric evidence of excess power up to 27% was measured during the electrolysis of heavy water using palladium cathodes. Maximum excess power was 0.52 W (...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره شماره
صفحات -
تاریخ انتشار 1992