Design and Simulation for a Two-dimensional Rectangle-Square Wave Micromixer

نویسنده

  • Xueye Chen
چکیده

An effective two-dimensional micromixer named rectangle-square wave micromixer with very simple structure has been presented. The rectangle-square wave micromixer based on split and recombination principle was simulated to analyze the fluid flow and the mixing efficiency. The flow rate, sample concentration, pressure drop at different position in the micromixer was researched. The simulation results show the micromixer can appear good performance for a wide range of flow rates with smaller pressure drop. The rectangle-square wave micromixer is proven to be effective and will have great potential to be integrated to other microfluidic systems. Copyright © 2014 IFSA Publishing, S. L.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Design and fabrication of an effective micromixer through passive method

Micromixer is a significant component of microfluidics particularly in lab-on-chip applications so that there has been a growing need for design and fabrication of micromixers with a shorter length and higher efficiency. Despite most of the passive micromixers that suffer from long mixing path and complicated geometry to increase the efficiency, our novel design suggests a highly efficient micr...

متن کامل

The effect of flow parameters on mixing degree of a three dimensional rhombus micromixer with obstacles in the middle of the mixing channel using oscillatory inlet velocities

The previous studies of authors on passive micromixers indicated that the micromixers dividing the flow to several layers, such as rhombus micromixers and micromixers with obstacles in the middle of the mixing channel, have higher mixing degree than other types. Also, using of oscillatory inlet velocities is an active method to enhance the mixing efficiency of micromixers. Therefore, in this st...

متن کامل

Conical Conformal Antenna Design using the CPM Method for MIMO Systems

Abstract- In this article, the design of conformal antennas has been discussed using the characteristic modes (CM) method. For this purpose, the vector wave function(VWF) has been utilized to achieve a two-dimensional mapping of the conformal antenna. In designing and analyzing of cone-shaped antennas applicable for multi-input multi-output (MIMO) systems, the most important goal is to achieve ...

متن کامل

Design and Simulation 4-Channel Demultiplexer Based on Photonic Crystals Ring Resonators

In this paper, a new design of demultiplexer based on two-dimensional photonic crystal ringresonator is proposed. The structure is made of a hexagonal lattice of silicon rods with therefractive index 3.46 in coefficient of air with refractive index 1. The transmission efficiencyand Quality factor for our proposed demultiplexer, respectively, are more than 65% and1600. The normalized transmissio...

متن کامل

A Novel Structure for Optical Channel Drop Filter using Two-Dimensional Photonic Crystals with Square Lattice

In the present paper a novel structure for optical channel drop filter (CDF) based on photonic crystal ring resonator with circular core has been proposed. In order to design the proposed CDF, the plan wave expansion (PWE) method is applied for calculation of band structure and photonic band gap while the transmission characteristics of proposed CDF have been calculated using the finite differe...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2014