Bulk Structural Investigation of the Reduction of MoO3 with Propeneand the Oxidation of MoO2 with Oxygen

نویسندگان

  • T. Ressler
  • J. Wienold
  • R. E. Jentoft
  • T. Neisius
چکیده

Reduction of MoO3 in propene and oxidation of MoO2 in oxygen are investigated by in situ X-ray diffraction (XRD) and Xray absorption spectroscopy (XAS). Temperature-programmed and isothermal experiments (573–773 K) are performed to elucidate the structural evolution of phases present during the reactions and, in addition, to reveal the solid-state kinetics of the processes involved. During the reduction of MoO3 in propene and the oxidation of MoO2, only crystalline MoO3 and MoO2 were detected by in situ XRD. The formation of a “Mo18O52”-type shear structure as intermediate during reduction of MoO3 in propene and during oxidation of MoO2 in oxygen was observed by in situ XAS. The solid-state kinetics of the reduction of MoO3 in propene exhibits a change in the rate-limiting step as a function of both temperature and extent of reduction. The solid-state kinetics of the oxidation of MoO2 is governed by three-dimensional diffusion. A schematic reaction mechanism for the reduction of MoO3 in propene and reoxidation in oxygen is proposed that consists of (i) generation of oxygen vacancies at the (100) or (001) facets by reaction with propene, (ii) vacancy diffusion in the MoO3 bulk, (iii) formation of Mo18O52-type shear structures in the lattice, and (iv) formation and growth of MoO2 nuclei. With respect to a redox mechanism for the partial oxidation of propene on MoO3, three stages are distinguished. (i) at temperatures below ∼600 K the participation of oxygen from the MoO3 bulk is negligible. (ii) At temperatures between ∼600 and ∼700 K oxygen vacancy diffusion in the bulk is sufficient to make a redox mechanism feasible, affording a partially reduced MoO3 under reaction conditions. (iii) At temperatures above ∼700 K sufficiently fast oxygen diffusion in the lattice combined with rapid formation and annihilation of crystallographic-shear planes permits the participation of a considerable amount of the lattice oxygen of MoO3 in the partial oxidation of propene. c © 2002 Elsevier Science (USA)

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Structure and properties of a Mo oxide catalyst supported on hollow carbon nanofibers in selective propene oxidation

In situ X-ray absorption spectroscopy (XAS) under reaction conditions of selective propene oxidation was employed to elucidate the local structure of as-prepared and activated molybdenum oxide supported on hollow vapor-grown carbon nanofibers (VGCNF). The local structure of asprepared MoxOy-VGCNF was very similar to that of hexagonal MoO3. During heat treatment in propeneand oxygen-containing a...

متن کامل

Formation of Bronzes during Temperature-programmed Reduction of MoO3 with Hydrogen - An In situ XRD and XAFS Study

The temperature-programmed reduction of MoO3 from 300 K to 773 K in 50 vol-% hydrogen in He (10 Pa) at different heating rates (0.1, 0.2, and 5 K/min) was investigated by in situ XRD and XAFS. At heating rates of ~ 0.1 and ~ 0.2 K/min the formation of the molybdenum bronze H0.34MoO3 was observed by in situ XRD in the early stage of the reduction of MoO3. At a heating rate of 5 K/min the formati...

متن کامل

Study of the effect of chemical reduction agent on the synthesis and structural properties of WO3-TeO2 and MoO3-TeO2 two-dimensional compounds.

Preparation of two-dimensional nanostructures of WTe2 and MoTe2 by chemical solution synthesis methods is of great importance. In different synthesis methods, different precursors and concentrations are used. In this paper, we used the chemical reduction reaction method from solution for our analysis. Binary compounds of WO3 - TeO2 and MoO3 - TeO2 were prepared in two processes with reduction a...

متن کامل

Structure and properties of molybdenum oxide nitrides as model systems for selective oxidation catalysts

Molybdenum oxide nitride (denoted as Mo(O,N)3) was obtained by ammonolysis of α-MoO3 with gaseous ammonia. Electronic and geometric structure, reducibility, and conductivity of Mo(O,N)3 were investigated by XRD, XAS, UV-Vis spectroscopy, and impedance measurements. Catalytic performance in selective propene oxidation was determined by online mass spectrometry und gas chromatography. Upon incorp...

متن کامل

Hydrogen evolution activity of NiMo-MoO2 produced by mechanical milling

In this study, mechanical alloying was done by a high-energy planetary ball milling technique. A mixture of NiO and MoO3 and graphite powders were used as initial materials. After milling of powder mixture with 40 wt.% additional graphite, a temperature of 400, 550 and 1000 °C for 1 h was considered for the heat treatment of powder mixture. Also, powder mixtures containing 60, 80 and 100 wt.% a...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2002