Trap and corral

Cells are constantly subjected to a host of external signals which can influence their state, phenotype and behavior. Mammalian cells are dependent on signals from surrounding cells to maintain viability, proliferate and coordinate their actions. During developmental and regenerative processes, these lateral signals between cells provide instructive cues informing stem cells how, when and where to differentiate. Moreover, differentiating cells often experience cell–cell contact events interspersed with bouts of motility, process extension and multi-cell agglomeration (Gage 2000 Science 287 1433–8) processes which are not easily recapitulated in existing cell capture devices. Here, we present a two-step process involving microwells to trap cells with high efficiency followed by the alignment of a PDMS mesh around the cells to corral them after the trapping. The microwells trap single cells and paired cells with up to 90% and 80% efficiencies, respectively. After seeding, the PDMS mesh is aligned with the seeded wells to create a 150 μm × 150 μm corral around each trap, allowing cells to interact in a larger arena. The corralling must be done in liquid after seeding because the seeding requires high cell densities to achieve near-full occupancy in the wells. Low-density seeding of the PDMS corrals alone can result in two cells being trapped in each well, but in those conditions, the two cells often engage in very little contact or none at all (and seeding obeys a non-desirable Poisson distribution). Interestingly, trapping cells in proximity and then corralling them elicits much higher contact times than simply seeding into corrals. (Some figures in this article are in colour only in the electronic version)