Physical state of cellulose in BmimCl: dependence of molar mass on viscoelasticity and sol-gel transition.
نویسندگان
چکیده
In this work, we investigated the correlation between the molar mass and the rheological properties of cellulose/1-butyl-3-methylimidazolium chloride (BmimCl) solutions, and provided the depolymerization kinetics of cellulose in BmimCl. Gel permeation chromatography was used to track the change in molar mass and kinetics as a function of the dissolution time. The molar mass of cellulose in BmimCl decreased significantly as the dissolution time increased, following a zeroth order rate law. The decrease of inter-chain friction induced by depolymerization resulted in a lower viscosity, shorter relaxation time, and lower activation energy. The activation energies for flow were distinctly different above and below the critical molar mass, which indicates that the relaxation mechanisms were not identical above and below the critical molar mass. The transition behavior of liquid crystalline phase also changed at the critical molar mass, which strongly demonstrated the effect of chain length on the formation of cholesteric phase. The exponents of Mark-Houwink-Sakurada and the radius of gyration showed that cellulose in BmimCl existed as a Gaussian chain in a theta solvent.
منابع مشابه
Dependence of Spectroscopic Properties of Copper Oxide Based Silica Supported Nanostructure on Temperature
Various concentrations of copper were embedded into silica matrix to xerogel forms using copper source Cu(NO3)2∙3H2O. The xerogel samples were prepared by hydrolysis and condensation of Tetraethyl Ortho-Silicate (TEOS) with determination of new molar ratio of the components by the sol-gel method. After ambient drying, the xerogel samples were heated from 60 to 1000˚C at a slow heating rate (50°...
متن کاملSynthesis and characterization of Alumina (Al2O3) nanoparticles prepared by simple sol-gel method
Alumina is one of the most widely used ceramic materials as catalysts, catalyst supports and absorbents, and also wear resistant coating. This study focused on fabricating and characterizing of alumina ceramic nanoparticles fabricated using new and simple sol-gel method. Aluminium oxide (Al2O3) nanoparticles were synthesized by iron (III) nitrate 9-hydrate as precursor. Physicochemical properti...
متن کاملSynthesis and characterization of Alumina (Al2O3) nanoparticles prepared by simple sol-gel method
Alumina is one of the most widely used ceramic materials as catalysts, catalyst supports and absorbents, and also wear resistant coating. This study focused on fabricating and characterizing of alumina ceramic nanoparticles fabricated using new and simple sol-gel method. Aluminium oxide (Al2O3) nanoparticles were synthesized by iron (III) nitrate 9-hydrate as precursor. Physicochemical properti...
متن کاملEffect of Concentration and Thermal Treatment on the Properties of Sol-Gel Derived CuO/SiO2 Nanostructure
Various concentrations of copper are embedded into silica matrix to xerogel form using copper source - Cu(NO3)2∙3H2O. The xerogel samples are prepared by hydrolysis and condensation of tetraethyl orthosilicate (TEOS) by the sol-gel method and with determination of new molar ratio of components H2O/TEOS to be 6.2. In this investigation, the necess...
متن کاملStructure of Lattice Strain and effect of sol concentration on the characterization of TiO2-CuO-SiO2 nanoparticles
We report on the synthesis, morphology, chemically and structurally of TiO2-CuO-SiO2 nanostructure with different precursors molar ratio and calcined temperatures. In the present work, ternary reactive powders in the TiO2-CuO-SiO2 systems have been obtained using the sol-gel method, by the simultaneous gelation of all cations. The compounds and other ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
- Physical chemistry chemical physics : PCCP
دوره 18 3 شماره
صفحات -
تاریخ انتشار 2016