Production of milk foams by steam injection : the effects of steam pressure 1 and nozzle design 2 3

نویسندگان

  • Carlos Jimenez-Junca
  • Alexander Sher
  • Jean-Claude Gumy
  • K. Niranjan
چکیده

*Corresponding author: Carlos Jimenez-Junca, e-mail: [email protected] , tel: 5 +57 320 845 45 27, Fax: +571 861 55 55 6 Faculty of Engineering, Universidad de la Sabana, Campus Puente el Común, Km.7 7 Autopista Norte de Bogotá, Chía 25001, Colombia 8 Nestlé R&D Marysville, 809 Collins Ave, Marysville, OH 43040, USA 9 Nestlé PTC Orbe, Rte de Chavornay 3, Orbe, CH-1350, Switzerland 10 Department of Food and Nutritional Sciences, University of Reading, Whiteknights PO 11 Box 226, Reading RG6 6AP (UK) 12

برای دانلود رایگان متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Hydrogen production by steam reforming of dimethyle ether over Cu/ZnO/Al2O3 and H-ZSM-5 catalysts: An experimental and modeling study

Hydrogen was produced by steam reforming of dimethyl ether (DME) using a physical mixture of commercial HZSM-5 zeolite (for DME hydrolyzing) and Cu/ZnO/Al2O3 (for methanol steam reforming) as a catalyst in a fixed bed reactor. The experiments were performed at atmospheric pressure and in a temperature range from 270 to 310 °C. The effects of feed temperature and gas hourly space velocity (GHSV)...

متن کامل

Exergy Recovery in Gas Pressure Compression Stations (GPCSs)

The exergy analysis is a proper method for performance evaluation of industrial systems. A generic and detailed analysis of the GPCSs on the second gas pipeline of Iran  is made by the means of exergy. The two main improvement measures of fuel pre-heating and steam injection technologies are presented for the current conventional stations. Steady state equations regarding the second law of ther...

متن کامل

On the Reduction of Optimization Time in Simulation of Oil Reservoirs

Thermal recovery techniques including Fast-SAGD process increases the production efciency of heavy oil reservoirs. Effective parameters in this study included injection and production rates, height of the injection, production, and offset wells, production and injection cycles, and pressure of the offset wells. In this study, optimization studies were performed. The objective function was defned a...

متن کامل

تعیین نقطۀ بهینۀ ترکیب آب‌شیرین‌کن چندمرحله‌ای تبخیری با نیروگاه سیکل ترکیبی

In this paper, the feasibility of using heat energy of steam turbine combined cycle power plant as the energy required to start up desalination systems has been studied. The optimal model of combined cycle power plant equipped with a multi-effect desalination plants in different design modes of the effects of desalination and steam pressure of the steam turbine output has been evaluated. In ord...

متن کامل

Investigation of a Single-reheat Condensing Steam Power Plant Based on Energy and Exergy Analysis

Nowadays, energy plays an important role in the economic and community development of country. Consequently, performance analysis of energy systems is one of the effective methods being used to prevent waste of energy resources. Among the different power generation technologies, steam power plants make a significant contribution to power generation in Iran, with a share of 47 % of electricity g...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2016