Ohio Waste Minimization Measurement Pilot Project: An Analysis of Pollution Prevention Measurement Options in Ohio
نویسنده
چکیده
منابع مشابه
DuPont Chambers Works Waste Minimization Project
In a joint U.S. Environmental Protection Agency ( EPA) and DuPont waste minimization project, fifteen waste streams were selected for assessment. The intent was to develop assessments diverse in terms of process type, mode of operation, waste type, disposal needed, and relative success in identifying good waste reduction options. The fifteen case study reports describe the wastes and the proces...
متن کاملTechnology Selection: Reduction of Organic Chemical Emission from a - Commercial Pesticide Manufacturing Facility
Industrial pollution prevention has been incorporated into several aspects of the chemical engineering curriculum at The University of Tennessee. One is an industrial internship program. This technology selection example focuses on a case from a pilot internship project sponsored by a pesticide manufacturer. This project involved synthesis and evaluation of waste management strategies for reduc...
متن کاملPollution Prevention in Ohio's Environmental Enforcement Settlements
environmental risk in Ohio, a standard enforcement settlement typically operates through the pollution control measures of treatment and disposal. Instead of reducing or eliminating pollutants, these measures usually rely on the cross-media shifting of pollutants to achieve compliance and deterrence. Waste generation often continues at the same levels, resulting in multi-media transfer of waste...
متن کاملPollution Prevention Assessments for Marine Maintenance and Commercial Printing Industries
This paper represents the results of ten pollution prevention/waste minimization assessments performed on marine maintenance and commercial printing industries in the Hampton Roads area of the Commonwealth of Virginia. The pollution prevention project is the result of a working partnership (the Partnership) formed between Old Dominion University Department of Civil and Environmental Engineering...
متن کاملUsing Neural Networks with Limited Data to Estimate Manufacturing Cost
Neural networks were used to estimate the cost of jet engine components, specifically shafts and cases. The neural network process was compared with results produced by the current conventional cost estimation software and linear regression methods. Due to the complex nature of the parts and the limited amount of information available, data expansion techniques such as doubling-data and data-cr...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره شماره
صفحات -
تاریخ انتشار 1996