Extremely Fine Pearlite by Continuous Cooling Transformation
نویسندگان
چکیده
An extremely fine, fully pearlitic structure with an interlamellar spacing 30–50 nm has been obtained during continuous cooling transformation at a rate as low as 0.1 C s, of the steel that is normally used to produce nanostructured bainite. The solutes cobalt and aluminium have been added to accelerate the rate of reaction and reduce the interlamellar spacing by increasing the free energy of transformation. The range of cooling rates over which the fully pearlitic state can be achieved is characterised.
منابع مشابه
Cellular automaton simulation of microstructure evolution during austenite decomposition under continuous cooling conditions
A two-dimensional diffusion based model is developed to describe transformation of austenite into ferrite and pearlite under continuous cooling conditions. The nucleation of ferrite is assumed to occur over grain boundaries and the nucleation of pearlite is assumed to be taking place all over the grain and at growing ferrite–austenite interfaces, when the composition and temperature conditions ...
متن کاملCharacterization and Morphological Analysis of Pearlite in an Eutectoid Steel
Pearlite is a lamellar product of eutectoid decomposition, which may form in steels and non-ferrous alloys during transformations under isothermal or continuous-cooling (1,2). A pearlite nodule is composed of multiple colonies; each colony has parallel lamellae, which are orientated differently with respect to lamellae in adjacent colonies. This also exhibits a wide range of interlamellar spaci...
متن کاملComplete Calculation of Steel Microstructure for Strong Alloys
Strong steels also have to be tough and hence rely on fine microstructures such as bainite or martensite, produced commercially by continuous cooling transformation. Depending on the detailed requirements, the steel-design process may explicitly require other higher temperature phases to be absent in the final microstructure. Such a procedure can be made easier by the availability of a good met...
متن کاملPrediction of Bainite Intervention in Ferrite-Pearlite Forging Steel I. Modeling
The successive ferrite (α) + pearlite (P) transformations from austenite (γ) have been modeled to predict the intervention of bainite in as-forged medium-carbon manganese steels. The kinetics of the diffusional transformations were calculated based on the classical nucleation-growth theory coupled with the CALPHAD multi-component thermodynamics. The description of growth rate of proeutectoid-α ...
متن کاملPOSCO Lectures: The Bainite Reaction
Examination of a time–temperature–transformation (TTT) diagram for an eutectoid carbon steel (Fig. 1), bearing in mind the fact that the pearlite reaction is essentially a high temperature one occurring between 550C and 720C and that the formation of the martensite is a low-temperature reaction, reveals that there is a wide range of temperature ∼250–550C within which neither of these phases for...
متن کامل