Low-noise differential transimpedance amplifier structure based on capacitor cross-coupled gm-boosting scheme
نویسندگان
چکیده
This paper presents a capacitor cross-coupled gm-boosting scheme for differential implementation of common-gate transimpedance amplifier (CG-TIA). A differential transimpedance amplifiers (DTIA) is designed by this scheme using two modified floating-biased CG stage with improved low corner frequency. Despite conventional methods for single-ended to differential conversion that increase the power and the noise for the same gain, the new DTIA gives a higher gain and hence reduces the inputreferred noise power. Design of the DTIA circuit using 0.13mm CMOS technology illustrates near 1.7 dB improvement in the circuit sensitivity and 5.2 dB enhancement in transimpedance gain compared to its single-ended counterpart. Operation at very low frequencies and stable dc coupling to photodiode are other features of the proposed DTIA. & 2008 Elsevier Ltd. All rights reserved.
منابع مشابه
Design of CMOS Broadband Transimpedance Amplifier with Cross Coupled Current Conveyor and series inductive Peaking
This paper hearsay a unique cross-coupled current conveyor based cmos transimpedance amplifier with series inductive peaking design to achieve an input capacitive load insensitive, low noise and augment the bandwidth of transimpedance amplifier. The peaking inductor is in series with the capacitor constituting a dominant pole. It boosts the band width of the amplifier.The whole transimpedance a...
متن کاملA Low Power Low Voltage Rail to Rail Constant gm Differential Amplifier with 150 dB CMRR and Enhanced Frequency Performance
This paper proposes a low voltage (±0.55V supply voltage) low power (44.65µW) high common mode rejection ratio (CMRR) differential amplifier (d.a.) with rail to rail input common mode range (ICMR), constant transconductance (gm) and enhanced frequency performance. Its high performance is obtained using a simple negative averaging method so that it cancels out the common mode input signals at th...
متن کاملA 6.03 GHz Low Power Transimpedance Amplifier TIA in CMOS 0.18μm Technology
Abstract— A low power and high gain transimpedance amplifier (TIA) in 0.18μm CMOS technology is presented. TIA with better performance is realized by reducing the effects of input parasitic capacitor. A negative admittance output stage enables the transimpedance gain and the bandwidth to be improved. Cadence tools were conducted for this proposed TIA by utilizing RF transistor model based on 0....
متن کاملDesign of differential low-noise amplifier with cross-coupled-SCR ESD protection scheme
The pin-to-pin electrostatic discharge (ESD) stress was one of the most critical ESD events for differential input pads. The pin-to-pin ESD issue for a differential low-noise amplifier (LNA) was studied in this work. A new ESD protection scheme for differential input pads, which was realized with cross-coupled siliconcontrolled rectifier (SCR), was proposed to protect the differential LNA. The ...
متن کاملAmplifying High-Impedance Sensors – Photodiode Example
Figure 1 shows the equivalent circuit of a transimpedance amplifier and a high-impedance source. IS represents the output current of the source. CS is the sum of the source’s output capacitance and the op amp’s input capacitance. RF, with the help of the op amp, converts IS to a voltage. At low frequencies, the op amp’s inverting input is forced to be at ground potential and IS must flow throug...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
- Microelectronics Journal
دوره 39 شماره
صفحات -
تاریخ انتشار 2008