A phase-plane approach to time-optimal control of single-DOF mechanical systems with friction

نویسندگان

  • Dong-Soo Choi
  • Seung-Jean Kim
  • In-Joong Ha
چکیده

In this paper, we attempt to solve the time-optimal control problem for single-degree-of-freedom (DOF) mechanical systems with friction, while taking into account not only the velocity-dependent control input constraint but also the state constraint. Direct application of the Pontryagin’s maximum principle (PMP) leads to a sixth-order nonlinear two-point boundary-value problem (TPBVP) which is very di;cult to solve numerically. In this context, we take a phase-plane analysis without resorting to the PMP. Thereby, the exact time-optimal solution can be obtained simply by solving a set of <rst-order di=erential equations with continuous right-hand sides. We also present some simulation results to demonstrate the practical use of the time-optimal solution. ? 2003 Elsevier Ltd. All rights reserved.

برای دانلود رایگان متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

A Low Friction Demanding Approach in Gait Planning for Humanoid Robots During 3D Manoeuvres

This paper proposes a gait planning approach to reduce the required friction for a biped robot walking on various surfaces. To this end, a humanoid robot with 18 DOF is considered to develop a dynamics model for studying various 3D manoeuvres. Then, feasible trajectories are developed to alleviate the fluctuations on the upper body to resemble human-like walking. In order to generate feasible w...

متن کامل

Friction Compensation for Dynamic and Static Models Using Nonlinear Adaptive Optimal Technique

Friction is a nonlinear phenomenon which has destructive effects on performance of control systems. To obviate these effects, friction compensation is an effectual solution. In this paper, an adaptive technique is proposed in order to eliminate limit cycles as one of the undesired behaviors due to presence of friction in control systems which happen frequently. The proposed approach works for n...

متن کامل

Stiffness control of a legged robot equipped with a serial manipulator in stance phase

The ability to perform different tasks by a serial manipulator mounted on legged robots, increases the capabilities of the robot. The position/force control problem of such a robot in the stance phase with point contacts on the ground is investigated here. A target plane with known stiffness is specified in the workspace. Active joints of the legs and serial manipulator are used to exert the de...

متن کامل

Optimal Control of Service Rate in a Service Center with Lapse (Research Note)

The purpose of this paper is to analyze the effect of a particular control doctrine applied to the service mechanism of a queuing process with lapse. It is assumed that the service discipline is FCFS (first come, first served), arrival process is Poisson, service time distribution is exponential, service process is one phase and the capacity is infinite. It is also assumed that the customer may...

متن کامل

Modifying a Conventional Grasping Control Approach for Undesired Slippage Control in Cooperating Manipulator Systems

There have been many researches on object grasping in cooperating systems assuming no object slippage and stable grasp and the control system is designed to keep the contact force inside the friction cone to prevent the slippage. However undesired slippage can occur due to environmental conditions and many other reasons. In this research, dynamic analysis and control synthesis of a cooperating ...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

عنوان ژورنال:
  • Automatica

دوره 39  شماره 

صفحات  -

تاریخ انتشار 2003