Study of Ac/rf Properties of Srf Ingot Niobium
نویسندگان
چکیده
In an attempt to correlate the performance of superconducting radiofrequency cavities made of niobium with the superconducting properties, we present the results of the magnetization and ac susceptibility of the niobium used in the superconducting radiofrequency cavity fabrication. The samples were subjected to buffer chemical polishing (BCP) surface and high temperature heat treatments, typically applied to the cavities fabrications. The analysis of the results show the different surface and bulk ac conductivity for the samples subjected to BCP and heat treatment. Furthermore, the RF surface impedance is measured on the sample using a TE011 microwave cavity for a comparison to the low frequency measurements.
منابع مشابه
Operating Experience with Superconducting Rf at Cesr and Overview of Other Srf Related Activities at Cornell University
In the two years past since 8 RFSC Workshop the major efforts of the SRF group at Cornell University were concentrated on the completion and commissioning of the superconducting RF system for the Cornell Electron Storage Ring (CESR) e+e− collider [1, 2]. Four singlecell niobium higher-order mode (HOM) damped cavities replaced four 5-cell normal conducting RF cavities. The RF system upgrade bega...
متن کاملReview of New Shapes for Higher Gradients
High gradient superconducting RF (SRF) cavities are needed for energy frontier superconducting accelerators. Progress has been made over the past decades and the accelerating gradient Eacc has been increased from a few MV/m to 42 MV/m in SRF niobium cavities. The corresponding peak RF magnetic field Hpk on the niobium cavity surface is approaching the intrinsic RF critical magnetic field Hcrit ...
متن کاملExpected Beam Performance of the Sns Linac*
The Spallation Neutron Source (SNS) project is a collaboration among Argonne, Brookhaven, Jefferson, Lawrence Berkeley, Los Alamos and Oak Ridge National Laboratories. The Linac, which injects beam into an accumulator ring, is comprised of both normal and superconducting rf (SRF) accelerating structures. Two room-temperature rf structures, a 402.5-MHz drift-tube linac (DTL) and an 805-MHz coupl...
متن کاملA comparative study of magnetostrictive strain in Pr3Fe24.75Co2.75Ti1.5-ingot and Pr3Fe24.75Co2.75Ti1.5-melt spun
In this work, the structural and magnetic properties of ingot and melt-spun Pr3Fe24.75Co2.75Ti1.5 compounds have been investigated. The structural characterization of the compounds, by X-ray powder diffraction, is evidenced for a monoclinic Nd3(Fe,Ti)29-type structure (A2/m space group). A 2-type FOMP have been observed in the magnetic AC susceptibility curves of the ingot and melt-spun compoun...
متن کامل“role of Metallurgy in the Thermal Conductivity of Superconducting Niobium”
Superconducting radio frequency (SRF) cavities for particle accelerators are fabricated using high purity niobium to allow for continuous high power operation. A hot-spot generated at a surface defect during accelerator operation can quench superconductivity and limit its performance. Increased heat conduction to the liquid helium bath dissipates hot spots, maintaining performance. Properly tre...
متن کامل