Actomyosin Cortical Mechanical Properties in Nonadherent Cells Determined by Atomic Force Microscopy.

نویسندگان

  • Alexander X Cartagena-Rivera
  • Jeremy S Logue
  • Clare M Waterman
  • Richard S Chadwick
چکیده

The organization of filamentous actin and myosin II molecular motor contractility is known to modify the mechanical properties of the cell cortical actomyosin cytoskeleton. Here we describe a novel method, to our knowledge, for using force spectroscopy approach curves with tipless cantilevers to determine the actomyosin cortical tension, elastic modulus, and intracellular pressure of nonadherent cells. We validated the method by measuring the surface tension of water in oil microdrops deposited on a glass surface. We extracted an average tension of T ∼ 20.25 nN/μm, which agrees with macroscopic experimental methods. We then measured cortical mechanical properties in nonadherent human foreskin fibroblasts and THP-1 human monocytes before and after pharmacological perturbations of actomyosin activity. Our results show that myosin II activity and actin polymerization increase cortex tension and intracellular pressure, whereas branched actin networks decreased them. Interestingly, myosin II activity stiffens the cortex and branched actin networks soften it, but actin polymerization has no effect on cortex stiffness. Our method is capable of detecting changes in cell mechanical properties in response to perturbations of the cytoskeleton, allowing characterization with physically relevant parameters. Altogether, this simple method should be of broad application for deciphering the molecular regulation of cell cortical mechanical properties.

برای دانلود رایگان متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Force microscopy of nonadherent cells: a comparison of leukemia cell deformability.

Atomic force microscopy (AFM) has become an important tool for quantifying mechanical properties of biological materials ranging from single molecules to cells and tissues. Current AFM techniques for measuring elastic and viscoelastic properties of whole cells are based on indentation of cells firmly adhered to a substrate, but these techniques are not appropriate for probing nonadherent cells,...

متن کامل

Correlating confocal microscopy and atomic force indentation reveals metastatic cancer cells stiffen during invasion into collagen I matrices

Mechanical interactions between cells and their microenvironment dictate cell phenotype and behavior, calling for cell mechanics measurements in three-dimensional (3D) extracellular matrices (ECM). Here we describe a novel technique for quantitative mechanical characterization of soft, heterogeneous samples in 3D. The technique is based on the integration of atomic force microscopy (AFM) based ...

متن کامل

Study of the mechanical properties of single cells as biocomposites by atomic force microscopy

Atomic force microscopy (AFM) is a unique method to study a single cell surface layer as a biocomposite. This chapter focuses on the advantages of two AFM modes, namely force spectroscopy (providing the information about local elastic properties of cells) and lateral force microscopy (LFM, revealing mechanical heterogeneity of cells surface), to make quantitative analysis of single cells mechan...

متن کامل

Mechanical Characterisation of HeLa Cells using Atomic Force Microscopy

Recently, atomic force microscopy (AFM) has been shown to be a suitable tool for imaging biological structures and their modification, adding to accurate morphological and cytomechanical information. AFM is capable of simultaneous nanometer spatial resolution and piconewton force detection, allowing detailed study of a cell surface morphology and monitoring of cell-tip interactions. Modern AFM ...

متن کامل

Finite Element Simulation of Contact Mechanics of Cancer Cells in Manipulation Based on Atomic Force Microscopy

The theory of contact mechanics deals with stresses and deformations which arise when the surfaces of two solid bodies are brought into contact. In elastic deformation contact occurs over a finite area. A regular method for determining the dimensions of this area is Hertz Contact Model. Appearance of atomic force microscope results in introduction of Contact ...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

عنوان ژورنال:
  • Biophysical journal

دوره 110 11  شماره 

صفحات  -

تاریخ انتشار 2016