Effect of mineral content on the nanoindentation properties and nanoscale deformation mechanisms of bovine tibial cortical bone.

In this paper, a multitechnique experimental and numerical modeling methodology was used to show that mineral content had a significant effect on both nanomechanical properties and ultrastructural deformation mechanisms of samples derived from adult bovine tibial bone. Partial and complete demineralization was carried out using phosphoric and ethylenediamine tetraacetic acid treatments to produce samples with mineral contents that varied between 37 and 0 weight percent (wt%). The undemineralized samples were found to have a mineral content of approximately 58 wt%. Nanoindentation experiments (maximum loads approximately 1000 microN and indentation depths approximately 500 nm) perpendicular to the osteonal axis for the approximately 58 wt% samples were found to have an estimated elastic modulus of approximately 7-12 GPa, which was 4-6x greater than that obtained for the approximately 0 wt% samples. The yield strength of the approximately 58 wt% samples was found to be approximately 0.24 GPa; 3.4x greater than that of the approximately 0 wt% sample. These results are discussed in the context of in situ and post-mortem atomic force microscopy imaging studies which show clear residual deformation after indentation for all samples studied. The partially demineralized samples underwent collagen fibril deformation and kinking without loss of the characteristic banding structure at low maximum loads (approximately 300 microN). At higher maximum loads (approximately 700 microN) mechanical denaturation of collagen fibrils was observed within the indent region, as well as disruption of interfibril interfaces and slicing through the thickness of individual fibrils leading to microcracks along the tip apex lines and outside the indent regions. A finite element elastic-plastic continuum mechanical model was able to predict the nanomechanical behavior of all samples on loading and unloading.